In the short-line model, which line effect is commonly neglected?
A Shunt capacitance
B Series resistance
C Series inductance
D Load current
Answer: A. Shunt capacitance. For a sufficiently short line, shunt charging is small compared with series impedance effects.
The nominal-π model represents line shunt admittance how?
A All at midpoint
B Only in series
C Split at both ends
D As a transformer
Answer: C. Split at both ends. Half the total shunt admittance is placed at each terminal.
In the nominal-T model, where is shunt admittance placed?
A At both terminals
B In the receiving load
C Inside the source
D At the midpoint
Answer: D. At the midpoint. The total series impedance is split around a central shunt branch.
A long line model accounts for line parameters how?
A Only at receiving end
B Distributed continuously
C As one resistor
D As a lumped capacitor only
Answer: B. Distributed continuously. Resistance, inductance, capacitance and leakage are distributed along its length.
In two-port ABCD notation, sending voltage depends on receiving voltage and what?
A Receiving current
B Rotor speed
C Fuel input
D Tower sag
Answer: A. Receiving current. Vs=A Vr+B Ir under the usual receiving-current direction.
For a reciprocal transmission line, which ABCD identity holds?
A AD+BC=0
B AD−BC=1
C A+B+C+D=0
D AB=CD²
Answer: B. AD−BC=1. Reciprocity gives determinant AD−BC equal to one.
A symmetrical two-port transmission line has which relation?
A B equals zero
B C equals zero
C A equals B
D A equals D
Answer: D. A equals D. Interchanging sending and receiving ends leaves a symmetrical network unchanged.
With the receiving end open, which current is zero in ABCD analysis?
A Ir
B Is
C Charging current everywhere
D Source current only
Answer: A. Ir. Open circuit means no receiving-end load current.
With a short circuit at the receiving end, which voltage is zero?
A Vs
B Line charging voltage
C Vr
D Source phase voltage
Answer: C. Vr. A shorted receiving terminal has zero voltage across it.
Why does receiving voltage rise on an open-ended long AC line?
A Copper loss
B Series resistance only
C Line charging capacitance
D Tower inductance
Answer: C. Line charging capacitance. Charging current interacting with series inductance produces the Ferranti rise.
For a lossless line, surge impedance is approximately the square root of what ratio?
A C divided by L
B R divided by X
C V divided by I²
D L divided by C
Answer: D. L divided by C. Zc≈√(L/C) when resistance and conductance are neglected.
Three-phase surge-impedance loading is expressed using line voltage V and surge impedance Zc as what?
A √3V/Zc
B 3VZc
C V²/Zc
D Zc/V²
Answer: C. V²/Zc. SIL=VLL²/Zc for a balanced three-phase line.
A line loaded below SIL tends to do what with reactive power?
A Absorb all of it
B Generate it
C Convert it to DC
D Store active power
Answer: B. Generate it. Its shunt capacitance dominates at light loading.
A line loaded above SIL tends to do what with reactive power?
A Generate more than it uses
B Absorb it
C Eliminate its inductance
D Change frequency
Answer: B. Absorb it. Series inductance demand dominates above natural loading.
A 220 kV line with Zc=400 Ω has SIL of about what?
A 55 MW
B 220 MW
C 121 MW
D 400 MW
Answer: C. 121 MW. VLL²/Zc=(220 kV)²/400 Ω≈121 MW.
Why may a long line need a shunt reactor at light load?
A Increase charging current
B Raise active output
C Absorb charging VARs
D Reduce conductor area
Answer: C. Absorb charging VARs. The reactor counteracts capacitive reactive-power generation.
What is the main steady-state effect of series compensation?
A Reduce line reactance
B Increase series reactance
C Remove line capacitance
D Lower system frequency
Answer: A. Reduce line reactance. A series capacitor offsets inductive reactance and can improve transfer capability.
A shunt capacitor near a receiving bus mainly supplies what?
A Mechanical power
B Reactive power
C Line resistance
D Fault current only
Answer: B. Reactive power. Local VAR supply supports voltage and reduces upstream reactive flow.
For a lossless single-machine infinite-bus line, transferred power varies approximately with what?
A cosδ only
B sinδ
C δ squared
D 1/sinδ
Answer: B. sinδ. The classical power-angle relation is proportional to sin of the load angle.
In the ideal lossless power-angle curve, maximum steady transfer occurs near which δ?
A 90 electrical degrees
B 0 degrees
C 30 degrees
D 180 degrees
Answer: A. 90 electrical degrees. The sine term reaches its maximum at 90 degrees.
A phase-shifting transformer changes which quantity to steer power flow?
A Phase angle
B Conductor resistivity
C Line length
D Grid frequency
Answer: A. Phase angle. A phase shift alters the angle difference across a network path.
Why can HVDC links connect asynchronous AC systems?
A Lines have zero resistance
B No control is needed
C They use no conductors
D Converters decouple frequencies
Answer: D. Converters decouple frequencies. Power electronic converters independently control each AC terminal.
Loss of synchronism on an AC transmission path means what?
A Voltage is always nominal
B Line resistance vanishes
C Frequency becomes DC
D Rotor angle becomes unstable
Answer: D. Rotor angle becomes unstable. Generators no longer maintain a stable relative electrical angle.
At natural loading, voltage magnitude along an ideal lossless line is approximately what?
A Zero at midpoint
B Doubles each kilometre
C Always triangular
D Flat
Answer: D. Flat. At SIL, reactive generation and absorption approximately balance.
For an ideal short line, ABCD constants are approximately what?
A A=D=1, C=0
B A=0, D=1, B=0
C A=D=0, C=1
D B=C=1 always
Answer: A. A=D=1, C=0. Neglecting shunt admittance gives [1 Z; 0 1].