In steady operation, a synchronous machine rotor runs at what speed relative to stator field?
A Half its speed
B Always faster
C The same speed
D Always stationary
Answer: C. The same speed. The rotor magnetic field locks to the rotating stator field.
Which formula gives synchronous speed in rpm for frequency f and poles P?
A 120f/P
B 60P/f
C 120P/f
D fP/120
Answer: A. 120f/P. The rotating field completes f electrical cycles per second and P/2 pole pairs per mechanical revolution.
A four-pole synchronous machine on 50 Hz runs at what speed?
A 1500 rpm
B 750 rpm
C 1000 rpm
D 3000 rpm
Answer: A. 1500 rpm. Ns=120×50/4=1500 rpm.
A six-pole synchronous machine on 60 Hz runs at what speed?
A 600 rpm
B 1800 rpm
C 3600 rpm
D 1200 rpm
Answer: D. 1200 rpm. Ns=120×60/6=1200 rpm.
In a common large alternator, where is the three-phase armature winding?
A On stator
B On shaft bearing
C In rotor field circuit
D On slip rings
Answer: A. On stator. Stationary armature windings make high-voltage insulation and output connection practical.
What normally supplies the main rotor field in a wound-field alternator?
A Stator AC directly
B DC excitation
C Load current only
D Mechanical friction
Answer: B. DC excitation. Direct current establishes the rotor magnetic poles.
In a brushed excitation system, slip rings carry what?
A Three-phase load current
B Cooling oil
C Shaft torque
D Rotor field current
Answer: D. Rotor field current. Slip rings and brushes deliver DC to the rotating field winding.
A brushless excitation system can supply rotor DC through what?
A Mechanical commutator
B Rotating rectifiers
C Stator load resistor
D Oil conservator
Answer: B. Rotating rectifiers. AC from a shaft-mounted exciter is rectified on the rotor.
Which rotor form commonly suits low-speed hydro alternators?
A Smooth two-pole rotor
B Squirrel-cage only
C Commutator rotor
D Salient-pole rotor
Answer: D. Salient-pole rotor. Many projecting poles suit lower rotational speeds.
Which rotor form commonly suits high-speed turbine alternators?
A Salient many-pole rotor
B Wound induction rotor
C Cylindrical rotor
D Shaded-pole rotor
Answer: C. Cylindrical rotor. A smooth cylindrical rotor withstands high mechanical speed.
What drives a synchronous generator mechanically?
A Prime mover
B DC field alone
C Capacitor bank
D Stator load current
Answer: A. Prime mover. A turbine or engine supplies shaft mechanical input.
A synchronous generator converts which energy form into electrical output?
A Chemical input directly
B Mechanical input
C Electrical input only
D Thermal input directly
Answer: B. Mechanical input. Its rotating field induces electrical power from mechanical shaft input.
A synchronous motor converts electrical input mainly into what?
A Mechanical output
B Only AC frequency
C Only DC voltage
D Core flux only
Answer: A. Mechanical output. It produces shaft mechanical power at synchronous speed.
How many electrical degrees separate balanced three-phase stator EMFs?
A 60°
B 120°
C 90°
D 180°
Answer: B. 120°. The three phase windings and induced EMFs are displaced by 120 electrical degrees.
At fixed poles, alternator frequency is proportional to which quantity?
A Field resistance only
B Load power factor only
C Rotor speed
D Brush size
Answer: C. Rotor speed. f=PN/120, so frequency follows mechanical rpm.
A four-pole alternator runs at 1500 rpm. What frequency does it generate?
A 50 Hz
B 25 Hz
C 100 Hz
D 60 Hz
Answer: A. 50 Hz. f=PN/120=4×1500/120=50 Hz.
For sinusoidal flux, phase EMF approximately follows which expression?
A 4.44fΦTk_w
B I²R
C 3VIcosφ
D V/ω
Answer: A. 4.44fΦTk_w. Ephase=4.44fΦTkw, where T is series turns per phase.
The winding factor k_w combines pitch factor with what other factor?
A Power factor
B Distribution factor
C Load factor
D Diversity factor
Answer: B. Distribution factor. kw=kp kd for a distributed short-pitched winding.
A short-pitched coil generally has pitch factor relative to unity that is what?
A Greater than 2
B Exactly zero always
C Infinite
D Less than 1
Answer: D. Less than 1. Short pitching reduces the fundamental EMF slightly while suppressing some harmonics.
A distributed winding generally has distribution factor relative to unity that is what?
A Greater than 2
B Always zero
C Infinite
D Less than 1
Answer: D. Less than 1. EMFs in different slots are phase displaced, so their phasor sum is less than arithmetic sum.
For a balanced star-connected armature, line voltage equals what?
A Phase voltage/3
B Phase voltage
C Three times phase voltage
D √3 times phase voltage
Answer: D. √3 times phase voltage. The difference of two phase voltages has magnitude √3Vphase.
For a balanced delta-connected armature, line current equals what?
A Phase current/3
B √3 times phase current
C Phase current
D Three times phase current
Answer: B. √3 times phase current. Line current is the phasor difference of adjacent phase currents.
An alternator open-circuit characteristic relates no-load generated voltage to what?
A Shaft torque only
B Stator resistance
C Field current
D Load current only
Answer: C. Field current. The OCC is measured versus excitation at a fixed speed.
During a short-circuit characteristic test, what is measured as field current changes?
A No-load voltage
B Bearing temperature only
C Armature short-circuit current
D Rotor speed only
Answer: C. Armature short-circuit current. The SCC plots short-circuit armature current against field excitation.
At 60 Hz with eight poles, what is synchronous speed?
A 450 rpm
B 1200 rpm
C 900 rpm
D 1800 rpm
Answer: C. 900 rpm. Ns=120×60/8=900 rpm.