A 4 m clay layer has e0 0.9, Cc 0.3 and stress rising 100 to 150 kPa. Approximate virgin settlement?
A 111 mm
B 25 mm
C 55 mm
D 220 mm
Answer: A. 111 mm. S = H Cc/(1+e0) log10(150/100) = 0.111 m, about 111 mm.
For double drainage through an 8 m layer, what is the maximum drainage path?
A 2 m
B 8 m
C 4 m
D 16 m
Answer: C. 4 m. With drainage at both boundaries, Hdr equals half the layer thickness.
For Gs 2.65 and e 0.65, the critical upward gradient is approximately what?
A 0.25
B 1.65
C 2.65
D 1.0
Answer: D. 1.0. icr = (2.65 – 1)/(1 + 0.65) = 1.0.
At a point, total vertical stress is 180 kPa and pore pressure 70 kPa. Effective stress is what?
A 70 kPa
B 180 kPa
C 250 kPa
D 110 kPa
Answer: D. 110 kPa. Effective stress equals 180 minus 70, giving 110 kPa.
For k 1e-5 m/s, i 0.4 and area 2 m2, Darcy discharge is what?
A 2e-5 m3/s
B 8e-6 m3/s
C 4e-6 m3/s
D 8e-5 m3/s
Answer: B. 8e-6 m3/s. Q = k i A = 1e-5 times 0.4 times 2 = 8e-6 m3/s.
A seepage exit is vulnerable to piping when which condition develops?
A High grain specific gravity
B Low effective stress
C Large confining stress
D Zero hydraulic gradient
Answer: B. Low effective stress. Upward seepage can reduce effective stress near the exit, allowing soil particles to be lifted.
A dry cohesionless slope has phi 30 degrees and beta 20 degrees. Approximate FS?
A 0.58
B 1.59
C 1.00
D 2.75
Answer: B. 1.59. FS = tan 30 / tan 20, approximately 1.59 under the dry infinite-slope assumption.
For level cohesionless backfill, lateral active pressure at depth z is what?
A Ka gamma z
B Kp gamma z
C Gamma z / Ka
D Ka z / gamma
Answer: A. Ka gamma z. The triangular active pressure distribution has intensity Ka gamma z at depth z.
At-rest lateral pressure in a normally consolidated profile is estimated from what?
A Ka times pore pressure
B K0 times vertical stress
C Kp times void ratio
D Friction angle times depth
Answer: B. K0 times vertical stress. At-rest lateral stress is K0 sigma-prime-v for the effective soil stress component.
A 100 kN point load lies directly above a point 2 m deep. Boussinesq vertical stress is about what?
A 3.0 kPa
B 25.0 kPa
C 11.9 kPa
D 47.7 kPa
Answer: C. 11.9 kPa. At r = 0, sigma-z = 3Q/(2 pi z²) = 300/(8 pi), about 11.9 kPa.
In a flow net, k 2e-5 m/s, head loss 3 m, Nf 4 and Nd 12. Discharge per unit width is what?
A 6e-5 m2/s
B 8e-5 m2/s
C 2e-4 m2/s
D 2e-5 m2/s
Answer: D. 2e-5 m2/s. q = k H Nf/Nd = 2e-5 times 3 times 4/12 = 2e-5 m2/s.
Anisotropic seepage is often transformed using which equivalent conductivity?
A Square root of kh kv
B kh plus kv
C kh minus kv
D kh times kv
Answer: A. Square root of kh kv. The geometric mean sqrt(kh kv) is used for the transformed isotropic flow-net problem.
For cv 2e-7 m2/s, t 1e7 s and Hdr 4 m, Tv equals what?
A 0.125
B 0.0125
C 0.5
D 2.0
Answer: A. 0.125. Tv = cv t/Hdr² = 2/16 = 0.125.
Normally consolidated clay has sigma-prime-p 240 kPa and current sigma-prime 160 kPa. OCR is what?
A 0.67
B 1.5
C 2.0
D 400
Answer: B. 1.5. OCR = 240/160 = 1.5, so the soil is overconsolidated.
For phi 30 degrees, Rankine Ka is approximately what?
A 0.33
B 0.50
C 1.00
D 3.00
Answer: A. 0.33. Ka = (1 – 0.5)/(1 + 0.5) = 1/3.
For phi 30 degrees, Rankine Kp is approximately what?
A 3.0
B 0.33
C 0.75
D 1.5
Answer: A. 3.0. Kp is the reciprocal of Ka for the same Rankine assumptions.
If sigma-prime-n is 100 kPa, c-prime is 10 kPa and phi-prime 30 degrees, tau-f is what?
A 50 kPa
B 10 kPa
C 110 kPa
D 67.7 kPa
Answer: D. 67.7 kPa. tau-f = 10 + 100 tan 30 degrees, about 67.7 kPa.
An 8 m saturated clay layer drains only at the top. What is Hdr?
A 4 m
B 2 m
C 16 m
D 8 m
Answer: D. 8 m. With a single drainage boundary, the maximum drainage distance is the full layer thickness.
At a given time, double drainage compared with single drainage changes Hdr how?
A Halves the drainage path
B Doubles the drainage path
C Leaves it unchanged
D Makes it zero
Answer: A. Halves the drainage path. Two-sided drainage halves the longest path for the same layer thickness.
A soil has D10 0.2 mm and D60 1.2 mm. Its Cu is what?
A 0.17
B 1.0
C 6
D 12
Answer: C. 6. Cu = D60/D10 = 1.2/0.2 = 6.
If D10 0.1 mm, D30 0.4 mm and D60 1.0 mm, Cc is what?
A 0.4
B 2.5
C 4.0
D 1.6
Answer: D. 1.6. Cc = D30²/(D10 D60) = 0.16/0.10 = 1.6.
A saturated soil has total stress 250 kPa and pore pressure 120 kPa. Effective stress is what?
A 120 kPa
B 130 kPa
C 250 kPa
D 370 kPa
Answer: B. 130 kPa. Subtract pore pressure from total stress: 250 – 120 = 130 kPa.
If head loss is 1.5 m over a 6 m seepage path, gradient is what?
A 0.04
B 1.5
C 0.25
D 4.0
Answer: C. 0.25. Hydraulic gradient i = delta-h/L = 1.5/6 = 0.25.
For a wall at rest, horizontal effective stress is 90 kPa and K0 is 0.6. Vertical effective stress is what?
A 54 kPa
B 90 kPa
C 150 kPa
D 180 kPa
Answer: C. 150 kPa. K0 = sigma-prime-h/sigma-prime-v, so sigma-prime-v = 90/0.6 = 150 kPa.
In one-dimensional consolidation, a smaller Hdr generally gives what?
A Slower drainage
B Higher Cc
C Faster consolidation
D Lower final stress
Answer: C. Faster consolidation. Because Tv varies inversely with Hdr squared, a shorter drainage path accelerates consolidation.