Which laboratory test is commonly used to establish a compaction curve?
A Unconfined compression test
B Proctor compaction test
C Direct shear test
D Consolidation test
Answer: B. Proctor compaction test. A Proctor test relates molding water content to dry density under controlled compactive effort.
Modified Proctor energy is higher mainly because it uses what?
A Lower drop height
B Fewer soil layers
C No hammer blows
D Greater compactive effort
Answer: D. Greater compactive effort. Modified Proctor compaction applies greater energy than the standard method.
Which field method can measure compacted soil density?
A Hydrometer method
B Sand replacement method
C Casagrande test
D Atterberg cup
Answer: B. Sand replacement method. The sand replacement method estimates an excavated hole volume for field density measurement.
Oven-dry water content is obtained by comparing wet and what mass?
A Dry soil mass
B Saturated mass only
C Container mass alone
D Bulk volume
Answer: A. Dry soil mass. Water content is the lost water mass divided by the remaining dry soil mass.
In Indian soil classification, the 75-micrometre sieve separates fines from what?
A Clay from silt exactly
B Coarser fractions
C Water from air
D Sand from gravel only
Answer: B. Coarser fractions. The 75-micrometre sieve separates the fine fraction from sand and larger particles.
The coefficient of uniformity is D60 divided by which size?
A D30
B D50
C D10
D D90
Answer: C. D10. Cu equals D60 over D10 from the particle-size distribution curve.
The coefficient of curvature uses which expression?
A D30 squared / D10D60
B D60 / D10 squared
C D10D60 / D30
D D50 / D10
Answer: A. D30 squared / D10D60. Cc is D30 squared divided by the product D10 times D60.
Liquidity index compares natural water content with which limits?
A Shrinkage and specific limits
B Void ratio and porosity
C Plastic and liquid limits
D Dry and saturated unit weights
Answer: C. Plastic and liquid limits. Liquidity index locates natural water content within the plasticity range.
A flow net’s equipotential lines connect points of equal what?
A Grain diameter
B Total hydraulic head
C Shear strength
D Dry density
Answer: B. Total hydraulic head. Equipotential lines represent locations with the same hydraulic head.
In an ideal flow net, flow lines cross equipotential lines at what angle?
A Right angles
B Thirty degrees
C Sixty degrees
D No fixed relation
Answer: A. Right angles. The two line families are orthogonal for isotropic soil under steady seepage.
Darcy discharge through a soil section is k times gradient times what?
A Void ratio
B Flow length squared
C Area
D Specific gravity
Answer: C. Area. Darcy’s law gives Q = k i A for one-dimensional laminar flow.
Which permeability test suits relatively coarse soils?
A Constant-head test
B Falling-head test
C Vane shear test
D Oedometer test
Answer: A. Constant-head test. A constant-head test is convenient when relatively high flow rates occur in coarse soil.
Which test is preferred for low-permeability fine soil?
A Falling-head test
B Constant-head test
C Plate-load test
D CBR test
Answer: A. Falling-head test. The falling-head method measures slow flow more sensitively in low-permeability soils.
Darcy’s law is generally valid for what seepage regime?
A Highly turbulent flow
B Cavitation flow
C Laminar flow
D Plastic flow
Answer: C. Laminar flow. Darcy’s linear relation is appropriate for laminar seepage through soil pores.
Piping describes progressive removal of soil by what?
A Drying shrinkage
B Thermal expansion
C Surface oxidation
D Seepage flow
Answer: D. Seepage flow. Seepage can transport particles and create progressive internal erosion called piping.
The capillary fringe lies immediately above which level?
A Ground surface always
B Water table
C Impervious bedrock
D Compaction layer only
Answer: B. Water table. Capillary forces draw water above the phreatic surface, forming the capillary fringe.
Lowering the water table can increase effective stress because it lowers what?
A Grain specific gravity
B Solid volume
C Pore pressure
D At-rest coefficient
Answer: C. Pore pressure. For soil below the water table, a reduction in pore pressure raises effective stress if total stress is otherwise unchanged.
An oedometer test primarily prevents what strain?
A Vertical strain
B Lateral strain
C Pore-pressure change
D Particle rearrangement
Answer: B. Lateral strain. The rigid ring confines the specimen laterally while vertical compression is measured.
Primary consolidation of saturated clay involves drainage of what?
A Soil solids
B Entrapped air only
C Excess pore water
D Cement paste
Answer: C. Excess pore water. Primary consolidation occurs as excess pore pressure dissipates and water drains from saturated soil.
For normally consolidated soil, OCR is approximately what?
A Zero
B Two
C Ten
D One
Answer: D. One. Normally consolidated soil has current effective stress equal to its maximum past effective stress.
Preconsolidation pressure represents what?
A Maximum past effective stress
B Current pore pressure
C Minimum total stress
D Critical hydraulic gradient
Answer: A. Maximum past effective stress. Preconsolidation pressure is the greatest effective vertical stress previously experienced.
Soil sensitivity is the ratio of undisturbed strength to what?
A Effective unit weight
B Liquid limit
C Permeability
D Remoulded strength
Answer: D. Remoulded strength. Sensitivity compares undisturbed undrained strength with remoulded strength at the same water content.
Which field test is useful in soft cohesive soil?
A Constant-head test
B Sieve analysis
C Sand cone test
D Vane shear test
Answer: D. Vane shear test. The field vane measures undrained shear strength in soft saturated clays.
In the standard SPT, the reported N value counts blows over which penetration?
A First 150 mm only
B Full 600 mm
C Last 50 mm
D Second and third 150 mm
Answer: D. Second and third 150 mm. The seating drive is excluded; N is the sum for the second and third 150-mm increments.
A high plasticity index generally indicates what?
A Broad plastic range
B Very low water affinity
C No clay fraction
D High gravel content
Answer: A. Broad plastic range. A larger PI means a wider range of water contents over which the soil behaves plastically.