Hydropower at a dam primarily uses water’s stored what?
A Chemical energy
B Nuclear energy
C Gravitational potential energy
D Electrostatic energy
Answer: C. Gravitational potential energy. Water descending through a head releases gravitational energy.
Ideal hydraulic input power is proportional to water flow Q and what other site quantity?
A Head H
B Generator pole count
C Transformer ratio
D Fuel heat rate
Answer: A. Head H. Phydraulic=ρgQH.
In hydropower, head describes what?
A Rotor pole count
B Line frequency
C Elevation or pressure difference
D Ash content
Answer: C. Elevation or pressure difference. Head is the effective height or pressure drop available to the turbine.
Water flow rate Q is commonly expressed in which unit?
A m³/s
B kWh
C Hz
D Ω
Answer: A. m³/s. Volumetric flow is volume passing per unit time.
At unchanged head and efficiency, doubling water flow does what to hydro power?
A Doubles it
B Halves it
C Quadruples it
D Leaves it zero
Answer: A. Doubles it. P=ρgQHη is directly proportional to Q.
A reservoir can help a hydro plant do what?
A Change AC frequency directly
B Eliminate turbines
C Create fossil fuel
D Store water for later
Answer: D. Store water for later. Stored water allows generation to be shifted in time.
Run-of-river hydropower generally has what relative to a large reservoir plant?
A More fossil fuel
B No water flow
C Less water storage
D No generator
Answer: C. Less water storage. Output more closely follows river flow when storage is limited.
Which pipe or conduit carries pressurized water toward a hydro turbine?
A Economizer
B Condenser
C Combustor
D Penstock
Answer: D. Penstock. A penstock directs water from intake to turbine.
Which turbine is an impulse design suited to high head and lower flow?
A Kaplan
B Pelton
C Francis
D Steam turbine
Answer: B. Pelton. Pelton buckets are driven by high-velocity water jets.
Which hydro turbine is often used at low head with high flow?
A Pelton
B Kaplan
C Gas turbine
D Steam turbine
Answer: B. Kaplan. Adjustable-blade axial-flow Kaplan turbines suit low-head sites.
Which hydraulic turbine is a common reaction type for medium heads?
A Pelton
B Francis
C Wind rotor
D Gas turbine
Answer: B. Francis. A Francis runner operates by both pressure and velocity changes.
What is the purpose of a draft tube on a reaction turbine?
A Recover exit kinetic energy
B Burn fuel
C Raise water temperature
D Reverse generator polarity
Answer: A. Recover exit kinetic energy. A diffuser helps recover pressure from the runner exhaust flow.
A surge tank on a hydro penstock helps reduce what transient?
A Water hammer
B Core hysteresis
C Generator slip
D Coal ash
Answer: A. Water hammer. It moderates pressure changes when water flow changes rapidly.
Pumped-storage hydropower stores energy by moving water when electricity is available to where?
A Upper reservoir
B Condenser
C Fuel bunker
D Generator stator
Answer: A. Upper reservoir. Pumps lift water uphill for later generation.
When is pumped storage typically dispatched to generate?
A Only during pumping
B Only at zero head
C High-demand periods
D Only when no grid exists
Answer: C. High-demand periods. Stored elevated water can supply electricity during high demand.
Why is pumped-storage round-trip efficiency below 100%?
A It creates extra water
B No turbine is used
C Conversion losses
D Frequency must be zero
Answer: C. Conversion losses. Pump, turbine, generator and hydraulic losses consume energy.
A wind turbine first converts wind energy into what at its shaft?
A DC chemical energy
B Mechanical rotation
C Nuclear heat
D Transformer flux only
Answer: B. Mechanical rotation. Airflow turns blades, providing mechanical input to a generator.
A photovoltaic cell converts sunlight directly into what form?
A Steam
B Rotating torque
C AC frequency
D DC electricity
Answer: D. DC electricity. The photovoltaic effect generates direct electrical output.
A grid-connected solar PV inverter converts panel DC into what?
A AC synchronized to grid
B Boiler steam
C Water pressure
D Coal heat
Answer: A. AC synchronized to grid. The inverter makes controlled AC suitable for grid connection.
Concentrating solar power uses mirrors mainly to produce what?
A Nuclear fuel
B Direct rotor DC
C Thermal energy
D Hydraulic head
Answer: C. Thermal energy. Concentrated sunlight heats a working fluid for a thermal cycle.
Geothermal generation draws useful heat from where?
A Coal ash
B Wind only
C Transmission lines
D Earth interior
Answer: D. Earth interior. Heat from geological resources drives a thermal power process.
Biomass-fired generation obtains energy from what feedstock?
A Uranium ore
B Pure water
C Sunlight on PV
D Organic material
Answer: D. Organic material. Organic matter can be combusted or converted to fuel.
Tidal generation relies primarily on which natural driver?
A Coal combustion
B Reactor fission
C Earth heat
D Gravitational tides
Answer: D. Gravitational tides. Moon and Sun gravity create periodic ocean water movement.
Why is wind or solar output called variable generation?
A Generator has no poles
B Resource changes with weather
C It always runs at peak
D Frequency shifts by design
Answer: B. Resource changes with weather. Available wind or sunlight varies across time.
Grid storage can help balance variable generation by doing what?
A Eliminate all losses
B Shift energy in time
C Increase fossil fuel
D Remove transmission lines
Answer: B. Shift energy in time. It charges when energy is available and discharges later.