Water-saturated fine earth moves downslope in flow-like lobes. Which movement fits?
A Rockfall
B Topple
C Earthflow
D Soil creep
Answer: C. Earthflow. An earthflow is a flow-like downslope movement of saturated fine-grained earth. Its speed varies with water content, material, and slope conditions.
An earthquake liquefies a weak layer beneath a firmer surface. Which movement may follow?
A Lateral spread
B Rock avalanche
C Soil creep
D Rotational slump
Answer: A. Lateral spread. A lateral spread involves lateral extension of stronger material over a weaker layer that has lost strength, often after liquefaction or shaking.
The side boundaries of a landslide mass are called its:
A Crown
B Flanks
C Toe
D Source zone
Answer: B. Flanks. Flanks are the sides that bound the displaced landslide mass, extending along its lateral margins.
In landslide anatomy, undisturbed material above the head scarp forms the:
A Toe
B Flank
C Debris tongue
D Crown
Answer: D. Crown. The crown is undisturbed material immediately above the head scarp of a landslide.
Which part marks the farthest downslope end of displaced material?
A Toe
B Crown
C Head scarp
D Flank
Answer: A. Toe. The toe is the lower end of displaced material, generally farthest downslope from its source.
Runout distance measures the distance from a slide source to its:
A Slopeβs steepest point
B First crack to toe
C Time until slope failure
D Source to farthest deposit
Answer: D. Source to farthest deposit. Runout distance measures how far the moving material travels from its source to its farthest point of deposition.
A landslide head repeatedly shifts upslope as new sections fail. This pattern is:
A Progradation
B Lateral spreading
C Retrogression
D Rotational sliding
Answer: C. Retrogression. Retrogression describes successive failures that extend upslope from the initial landslide head.
What crack pattern may appear where a moving slope mass is being pulled apart?
A Stream terraces
B Tension cracks
C Dune ripples
D Glacial grooves
Answer: B. Tension cracks. Tension cracks open where a slope mass is pulled apart, often upslope of the moving landslide body.
Why can intense rain trigger debris flows after a wildfire?
A Stronger root networks
B Lower runoff rates
C More slope cohesion
D Bare, erodible hillslopes
Answer: D. Bare, erodible hillslopes. Wildfire can remove vegetation and leave loose soil more exposed. Intense rain can then mobilize sediment into debris flows.
Subsurface drains may stabilize a slope mainly by:
A Increasing slope weight
B Raising groundwater levels
C Lowering pore pressure
D Removing toe support
Answer: C. Lowering pore pressure. Subsurface drains lower groundwater or pore pressure, which can improve stability in some slopes.
A blocked hillside drain before a storm most likely causes:
A Water buildup in slope
B Lower pore pressure
C Rapid soil drying
D Greater root strength
Answer: A. Water buildup in slope. Blocked drainage allows water to accumulate, increasing saturation and potentially raising pore pressure within slope material.
A landslide inventory is chiefly a record of:
A Annual rainfall and winds
B Past slide locations and types
C River depth and discharge
D Soil color and albedo
Answer: B. Past slide locations and types. A landslide inventory records locations and characteristics of past landslides, supporting susceptibility and hazard analysis.
A reservoir drops quickly while water inside its bank drains slowly. Which slope hazard is likely?
A Creep acceleration
B Rapid drawdown instability
C Talus accumulation
D Debris fan growth
Answer: B. Rapid drawdown instability. During rapid drawdown, external water support falls while internal pore pressures may remain high, potentially destabilizing the bank.
Which rapid mass movement is dominated by water and fine sediment?
A Mudflow
B Rockfall
C Topple
D Translational slide
Answer: A. Mudflow. A mudflow is a fluid downslope movement dominated by water mixed with fine sediment. Terminology can vary among classification systems.
What does the source zone identify in a landslide?
A Where debris finally settles
B The farthest runout point
C The lower deposit edge
D Where slope failure begins
Answer: D. Where slope failure begins. The source zone is where initial failure begins and material starts moving downslope.
A natural landslide dam suddenly breaches. What hazard can strike downstream?
A Ground subsidence
B Coastal erosion
C Flash flooding
D Glacial advance
Answer: C. Flash flooding. When a landslide dam fails or is overtopped, stored water can rush downstream and cause flooding.
Adding fill near a slope crest can raise failure risk because it:
A Adds load to slope
B Reduces driving stress
C Strengthens bedrock
D Lowers slope angle
Answer: A. Adds load to slope. Added fill increases load and may increase driving forces, depending on the slope and material conditions.
A road cut steepens a lower slope face. Why may instability increase?
A More support at toe
B Lower shear stress
C Steeper face raises stress
D Roots deepen immediately
Answer: C. Steeper face raises stress. A steepened slope face can increase downslope driving stress and may remove support, making failure more likely.
Leaking irrigation water on a hillside can promote movement by:
A Cooling bedrock rapidly
B Saturating slope material
C Reducing pore pressure
D Binding soil particles
Answer: B. Saturating slope material. Leaking irrigation water may infiltrate slope material, increase saturation, and lower its resistance to movement.
A new home is planned beside a mapped landslide path. The safer location is:
A Below unstable slope
B Inside debris channel
C At stream crossing
D Outside mapped runout zone
Answer: D. Outside mapped runout zone. Keeping buildings outside mapped runout zones reduces exposure to material that may travel downslope during a failure.
Rockfall nets and catch ditches below a cliff are installed to:
A Raise pore pressure
B Steepen cliff faces
C Trigger soil creep
D Catch falling fragments
Answer: D. Catch falling fragments. Nets and catch ditches intercept or contain falling rock fragments before they reach roads or other exposed areas.
Repeated surveys of cracks and ground markers help investigators:
A Predict exact failure dates
B Track changes over time
C Measure rock age only
D Map soil color only
Answer: B. Track changes over time. Repeated measurements can reveal whether a slope is moving and how its displacement changes over time; they cannot predict an exact failure date.
A landslide susceptibility map identifies:
A Places with recent floods
B Sites with high winds
C Areas prone to slope failure
D Zones with dark soils
Answer: C. Areas prone to slope failure. Susceptibility maps show areas where landslides are more likely based on terrain and other factors, not the exact timing of a future event.
Which landscape pattern can indicate an older landslide?
A Curved scarps and hummocks
B Parallel river bars
C Circular dune ridges
D Straight beach berms
Answer: A. Curved scarps and hummocks. Curved scarps and hummocky, disrupted ground can mark old landslide terrain, though field context is needed to confirm it.
A landslide blocks a river channel. What may form upstream?
A Temporary lake formation
B Sudden stream incision
C Glacial moraine growth
D Coastal cliff retreat
Answer: A. Temporary lake formation. A landslide dam can impound water upstream. If it overtops or fails, flooding may occur downstream.