Induction Motors MCQs (Set-1)

What creates the rotating magnetic field in a three-phase induction motor?

A DC rotor supply
B Brush commutation
C Three-phase stator currents
D Mechanical gearing

Synchronous speed in rpm is given by which formula for frequency f and pole count P?

A 60P/f
B 120f/P
C fP/120
D 120P/f

What is synchronous speed for a four-pole motor on 50 Hz supply?

A 750 rpm
B 1500 rpm
C 1000 rpm
D 3000 rpm

What is synchronous speed for a six-pole motor on 60 Hz supply?

A 1200 rpm
B 600 rpm
C 1000 rpm
D 1800 rpm

Which expression defines motoring slip s?

A Nr/Ns only
B (Ns−Nr)/Ns
C (Ns+Nr)/Ns
D Ns/Nr only

At standstill, what is induction motor slip?

A 0
B 0.5
C Infinity
D 1

For normal induction-motor operation, slip is generally in which range?

A Between 0 and 1
B Exactly 0
C Less than −1
D Greater than 2

Why is steady electromagnetic torque absent at exact synchronous rotor speed?

A Rotor current is DC
B Stator frequency doubles
C No relative field motion
D Core loss becomes zero

A 1500 rpm field drives a rotor at 1440 rpm. What is slip?

A 2%
B 6%
C 4%
D 10%

Rotor current frequency during motoring equals what?

A Slip times supply frequency
B Supply frequency/slip
C Synchronous speed
D Pole count times voltage

At standstill, rotor current frequency equals what?

A Zero
B Supply frequency
C Half supply frequency
D Twice supply frequency

At 50 Hz supply and 4% slip, what is rotor frequency?

A 4 Hz
B 12.5 Hz
C 50 Hz
D 2 Hz

Which two quantities set stator field synchronous speed?

A Voltage and current
B Frequency and poles
C Torque and resistance
D Flux and efficiency

How can the rotation direction of a three-phase induction motor be reversed?

A Swap all three phases cyclically
B Increase voltage only
C Swap two supply phases
D Reduce load only

A squirrel-cage rotor has conducting bars connected at their ends by what?

A Slip rings
B Commutator segments
C Field rheostat
D End rings

Which rotor type uses slip rings for external access?

A Wound rotor
B Squirrel cage
C Solid steel rotor
D Permanent magnet rotor

External rotor resistance can be added during starting of which motor?

A Standard cage motor
B Permanent magnet motor
C Synchronous condenser
D Wound-rotor motor

Which rotor is valued for simple and rugged construction?

A Squirrel cage
B Wound rotor only
C Commutator rotor
D DC field rotor

How does a cage rotor receive its operating electrical power?

A Direct DC brushes
B Battery inside rotor
C Electromagnetic induction
D Optical excitation

In motor mode, the rotor runs in which direction relative to stator field?

A Same direction, slower
B Opposite at same speed
C Same at exact speed
D Stationary always

Why are stator iron cores laminated?

A Limit eddy-current loss
B Raise rotor slip
C Remove copper loss
D Change supply frequency

A much larger air gap usually causes what no-load change?

A Zero magnetizing current
B Lower supply frequency
C No leakage flux
D Higher magnetizing current

What is a large component of induction motor no-load current?

A Rated rotor copper loss
B Shaft torque current
C Magnetizing current
D DC field current

In a balanced three-phase stator, phase currents are separated by how many electrical degrees?

A 60°
B 120°
C 90°
D 180°

Why is a balanced three-phase induction motor self-starting?

A Rotor reaches synchronous speed instantly
B DC current flows in stator
C No rotor current is needed
D Rotating field exists at standstill