Distribution Systems MCQs (Set-4)

A 1 MW three-phase load on 11 kV at 0.8 power factor draws about what current?

A 65.6 A
B 45.5 A
C 100 A
D 131 A

A 100 kVA three-phase transformer has a 415 V secondary. Its rated current is about what?

A 58 A
B 100 A
C 139 A
D 241 A

A feeder carries 100 A at 0.8 lagging pf, with R=0.2 Ξ© and X=0.3 Ξ© per phase. Approximate line drop?

A 59 V
B 34 V
C 83 V
D 100 V

A balanced feeder has 0.2 Ξ© resistance per phase and 100 A current. What is total copper loss?

A 6 kW
B 2 kW
C 20 kW
D 60 kW

A 100 kW load is corrected from 0.8 to 0.95 power factor. Required capacitor size is about what?

A 42 kvar
B 20 kvar
C 75 kvar
D 100 kvar

A 2 MW three-phase load at 11 kV and 0.9 power factor draws about what current?

A 117 A
B 58 A
C 182 A
D 350 A

A 250 kVA transformer supplies a load at 0.8 power factor. Real power is what?

A 125 kW
B 200 kW
C 250 kW
D 312.5 kW

Why can a feeder with high distributed-generation penetration need directional protection?

A Resistance becomes zero
B Frequency doubles
C Loads disappear
D Power may reverse

What does a distribution sectionalizer do during an upstream recloser dead time?

A Clears fault current itself
B Isolates counted fault section
C Raises feeder voltage
D Changes phase sequence

A fuse-saving scheme aims for the recloser to do what on a temporary fault?

A Wait for fuse always
B Trip every feeder
C Remain permanently open
D Fast trip first

When selective fuse coordination is preferred, which device should clear a lateral fault first?

A Substation transformer
B All feeder relays
C Generator breaker
D Lateral fuse

A three-phase feeder carries 100 A with 0.5 Ξ© resistance per phase. Total IΒ²R loss equals what?

A 15 kW
B 5 kW
C 50 kW
D 150 kW

For a grounded-wye secondary, which current component sums in the neutral during unbalance?

A Balanced positive sequence
B Line-to-line voltage
C Residual phase current
D Transformer flux

Why can third-harmonic currents add in the neutral of a four-wire system?

A They are 120Β° apart
B They are DC-free
C They cancel pairwise
D They are in phase

An OLTC changes taps while maintaining what?

A Open circuit
B Customer supply
C Zero current
D Fixed transformer ratio

A voltage regulator set point is 1.0 pu. What voltage is this relative to nominal?

A 10%
B 50%
C 100%
D 200%

A feeder has SAIFI=4 interruptions/customer-year. For 100 customers, how many customer interruptions occurred?

A 25
B 100
C 4000
D 400

A utility records 900 customer-hours of interruption for 300 customers. SAIDI is what?

A 0.33 hours/customer
B 300 hours/customer
C 3 hours/customer
D 900 hours/customer

If SAIDI is 8 hours/customer and SAIFI is 4 interruptions/customer, CAIDI is what?

A 4 hours/interruption
B 8 hours/interruption
C 32 hours/interruption
D 2 hours/interruption

A high-resistance fault may challenge ordinary overcurrent protection because fault current can be what?

A Always infinite
B Exactly rated
C Relatively low
D Purely reactive

A capacitor bank switched onto an energized feeder can create what transient?

A Mechanical torque
B Inrush current
C DC generation
D Lower insulation stress always

A feeder voltage sag during a nearby fault is mainly due to what?

A Change in conductor material
B Current through source impedance
C Lower system frequency only
D Transformer turns increase

A distributed generator can raise local voltage when exporting power because what changes?

A Line resistance vanishes
B Voltage becomes DC
C Feeder drop reverses
D Neutral opens always

An earth-fault relay often detects which quantity?

A Positive-sequence voltage only
B Residual current
C Active energy
D Transformer oil level

During outage restoration, a normally open tie switch helps by transferring what?

A Load to healthy feeder
B Fault current to ground
C Generator fuel
D Transformer core flux