Directly above a DME station at 6,000 ft, what distance is approximately displayed?
A 0.50 NM
B 0.75 NM
C 1.50 NM
D 0.99 NM
Answer: D. 0.99 NM. DME indicates slant range. Six thousand feet is about 0.99 nautical miles.
An aircraft is 6 NM horizontally and 6 NM above a DME station. What slant range is shown?
A 6.0 NM
B 8.5 NM
C 7.2 NM
D 12.0 NM
Answer: B. 8.5 NM. Slant range is √(6²+6²), approximately 8.49 NM.
At 120 kt groundspeed on a 3° glide path, what descent rate is closest?
A 636 ft/min
B 400 ft/min
C 530 ft/min
D 800 ft/min
Answer: A. 636 ft/min. A 3° path requires about 5.3 times groundspeed in knots, giving roughly 636 ft/min.
A VOR CDI has three dots deflection, with each dot representing 2°. What is the angular deviation?
A 2°
B 4°
C 6°
D 8°
Answer: C. 6°. Three graduations at 2° each indicate 6° of course deviation.
An aircraft operating at FL200 in U.S. ADS-B-required airspace needs which link?
A 978 MHz UAT
B 121.5 MHz
C VHF voice
D 1090ES
Answer: D. 1090ES. The FAA requires 1090 MHz Mode S Extended Squitter at and above FL180.
Which frequency does the UAT ADS-B link use?
A 1030 MHz
B 1090 MHz
C 978 MHz
D 121.5 MHz
Answer: C. 978 MHz. Universal Access Transceivers operate on 978 MHz in the U.S. system.
How often does ADS-B Out normally broadcast aircraft data?
A Once per minute
B Once per second
C Every five seconds
D Only on request
Answer: B. Once per second. FAA guidance states ADS-B Out broadcasts aircraft data once per second.
For ADS-B altitude reporting, which altitude source should match the transponder source?
A Barometric source
B Radio altimeter
C Radar height
D GPS elevation
Answer: A. Barometric source. The FAA requires ADS-B to use the same altimetry source as the transponder.
Which frequency band contains ILS localizer channels?
A 118–136.975 MHz
B 960–1215 MHz
C 108.10–111.95 MHz
D 329–335 MHz
Answer: C. 108.10–111.95 MHz. FAA guidance places localizer channels in the 108.10 to 111.95 MHz range.
If glide-slope reception fails but the localizer remains usable, what guidance remains?
A DME-only guidance
B VOR-only guidance
C No lateral guidance
D Localizer-only guidance
Answer: D. Localizer-only guidance. The localizer can still provide lateral runway alignment without vertical glide-slope guidance.
An aircraft on the 090 radial lies in which direction from the VOR?
A West
B East
C North
D South
Answer: B. East. VOR radials are bearings outward from the station; 090° extends eastward.
With unchanged range errors, what is the approximate effect of doubling HDOP?
A Horizontal error doubles
B Vertical error vanishes
C Position becomes exact
D Only heading changes
Answer: A. Horizontal error doubles. Dilution of precision scales the effect of range measurement errors on position.
A blocked static port most directly causes what altimeter behavior?
A Indication doubles
B Needle points north
C Reading becomes radio height
D Altitude indication freezes
Answer: D. Altitude indication freezes. Without changing static pressure at the instrument, the altimeter cannot update normally.
With the pitot inlet blocked, drain open, and static source clear, what does the ASI tend to show?
A Maximum airspeed
B Radio altitude
C Zero airspeed
D Ground speed
Answer: C. Zero airspeed. The open drain lets trapped pitot pressure equalize, so the airspeed indicator loses its differential pressure.
When RAIM fault exclusion is active, what happens to a detected faulty satellite measurement?
A It is averaged twice
B It is excluded
C It sets baro pressure
D It changes the VOR radial
Answer: B. It is excluded. Fault exclusion removes the suspect measurement from the navigation solution when sufficient redundancy exists.
At 90 kt groundspeed on a 3° glide path, what descent rate is closest?
A 318 ft/min
B 636 ft/min
C 795 ft/min
D 477 ft/min
Answer: D. 477 ft/min. Using about 5.3 × groundspeed gives 5.3 × 90 ≈ 477 ft/min.
Which position source is normally paired with an ADS-B Out transmitter?
A Compatible GPS source
B ADF needle
C Marker beacon
D Radio altimeter
Answer: A. Compatible GPS source. FAA installation guidance requires ADS-B Out to use a compatible position source; GPS is the available compliant source.
What address length identifies an aircraft in Mode S?
A 12-bit
B 16-bit
C 24-bit
D 32-bit
Answer: C. 24-bit. Mode S aircraft identification uses a unique 24-bit address.
What information is primarily selected by a Mode A transponder code?
A Pressure altitude
B Aircraft identity code
C Ground speed
D Runway length
Answer: B. Aircraft identity code. Mode A reports the selected four-digit identity code to surveillance systems.
What traffic can TCAS fail to track through its normal surveillance?
A Non-transponder aircraft
B Mode S aircraft
C Mode C aircraft
D ADS-B aircraft
Answer: A. Non-transponder aircraft. TCAS relies on transponder replies, so aircraft without an operating transponder may not be tracked.
Two VOR bearings from separate stations intersect. What do they define?
A Glide path
B Pressure altitude
C Radio horizon
D Position fix
Answer: D. Position fix. The intersection of two known bearings provides a navigational position fix.
Which digits are valid in a four-digit transponder code?
A 1 through 8
B 0 through 9
C 0 through 7
D 2 through 9
Answer: C. 0 through 7. Transponder octal codes use digits zero through seven; digits eight and nine are not valid.
Why can higher cruise altitude improve VHF communication range?
A Changes carrier frequency
B Raises radio horizon
C Boosts receiver power
D Removes terrain
Answer: B. Raises radio horizon. Greater antenna height increases line-of-sight range over the Earth’s curvature.
What happens when an ILS localizer frequency is tuned on a paired receiver?
A Glide-slope channel pairs
B DME turns off
C GPS becomes primary
D Transponder code changes
Answer: A. Glide-slope channel pairs. ILS channelization pairs the glide-slope receiver frequency with the selected localizer channel.
With adequate redundancy, how does an integrity monitor respond to inconsistent GNSS data?
A Raises the glide path
B Changes baro setting
C Flags the solution
D Toggles the transponder
Answer: C. Flags the solution. Integrity monitoring warns the crew when satellite measurements cannot support a trustworthy position.