With a VOR CDI centered and a FROM flag displayed, what does the selected course do?
A Leads away
B Leads toward
C Points north
D Shows distance
Answer: A. Leads away. A FROM indication means the selected course extends away from the VOR station.
Why can DME show more than horizontal range when overhead a station?
A It measures ground speed
B It includes wind drift
C It measures slant range
D It uses magnetic bearing
Answer: C. It measures slant range. DME measures straight-line distance between aircraft and station, including vertical separation.
How does ADS-B Out differ from secondary radar surveillance?
A It waits for interrogation
B It broadcasts position
C It measures echo time
D It uses runway lights
Answer: B. It broadcasts position. ADS-B periodically broadcasts position data instead of relying on a radar interrogation for each report.
How many GNSS satellites are normally needed for a three-dimensional fix with receiver clock offset?
A Two
B Three
C Five
D Four
Answer: D. Four. Four independent satellite measurements solve three position coordinates and receiver clock bias.
What does low HDOP generally indicate?
A Favorable satellite geometry
B Weak radio audio
C Large altitude error
D High wind speed
Answer: A. Favorable satellite geometry. Low horizontal dilution of precision indicates a stronger satellite geometry for horizontal positioning.
What does RAIM assess in a GNSS receiver?
A Engine vibration
B Position integrity
C Radio altitude
D Runway lighting
Answer: B. Position integrity. Receiver autonomous integrity monitoring checks whether satellite measurements support a trustworthy position.
What does SBAS add to satellite navigation?
A Runway radar
B VHF voice
C Wide-area corrections
D Fuel predictions
Answer: C. Wide-area corrections. Satellite-based augmentation systems broadcast corrections and integrity information over a broad area.
What is a main GBAS role near an airport?
A Oceanic voice relay
B Weather radar scan
C Cabin pressure control
D Local approach corrections
Answer: D. Local approach corrections. Ground-based augmentation uses local reference measurements to support precision approach guidance.
A failed primary display can be handled by which feature?
A DME hold mode
B Reversionary display mode
C Audio test mode
D Pitot drain mode
Answer: B. Reversionary display mode. Reversionary modes rearrange essential information on a remaining display after a display failure.
Which inputs commonly feed an air data computer?
A Pitot and static pressure
B Magnetic and radio signals
C Fuel and oil pressure
D Radar and GPS altitude
Answer: A. Pitot and static pressure. Air data computers use pitot and static pressures, often with temperature, to calculate air data.
Which sensor group supports a strapdown AHRS?
A Pitot and static ports
B DME and VOR
C Radar and transponder
D Gyros and accelerometers
Answer: D. Gyros and accelerometers. Rate gyros and accelerometers measure aircraft motion for attitude and heading reference computation.
Why does an inertial navigation solution drift over time?
A VOR signals rotate
B DME loses slant range
C Small sensor errors accumulate
D Static pressure rises
Answer: C. Small sensor errors accumulate. Bias and measurement errors integrate over time, causing inertial position and velocity estimates to drift.
What does an FMS use its navigation database for?
A Coded routes and procedures
B Engine oil limits
C Cabin service menus
D Paint records
Answer: A. Coded routes and procedures. The FMS database contains coded fixes, airways, and procedures used to construct flight paths.
An altitude-hold autopilot mode primarily uses which feedback?
A Cabin temperature
B Barometric altitude
C Fuel quantity
D Radio bearing
Answer: B. Barometric altitude. The altitude-hold mode uses altitude information to command pitch changes that maintain the selected level.
What is the main distinction between a flight director and autopilot?
A Radar versus radio
B Heading versus altitude
C Display versus sensor
D Cues versus control
Answer: D. Cues versus control. A flight director displays commands; an autopilot can move controls to follow selected guidance.
When a VOR/DME facility is tuned, what commonly happens to DME channel selection?
A It uses a voice channel
B It selects GPS only
C It pairs automatically
D It follows the marker
Answer: C. It pairs automatically. VOR and ILS channelization pairs associated DME channels through the selected navigation frequency.
What unique identifier is assigned to a Mode S transponder installation?
A 24-bit aircraft address
B Four-digit squawk only
C Six-letter call sign
D Eight-bit runway code
Answer: A. 24-bit aircraft address. Mode S uses a unique 24-bit address to support selective interrogation and aircraft identification.
TCAS obtains traffic information mainly from what?
A Weather radar echoes
B VOR radials
C Runway beacons
D Transponder replies
Answer: D. Transponder replies. TCAS interrogates nearby transponders and processes their replies to track traffic.
What adjustment helps airborne weather radar scan the intended altitude band?
A OBS course
B Antenna tilt
C Baro setting
D Audio squelch
Answer: B. Antenna tilt. Antenna tilt controls the radar beam’s vertical pointing direction relative to the aircraft.
Predictive windshear avionics can use which sensor?
A Magnetometer
B DME antenna
C Weather radar
D Marker receiver
Answer: C. Weather radar. Predictive windshear functions can analyze weather-radar returns for hazardous windshear ahead.
What information does EGPWS compare with terrain?
A Aircraft flight path
B Fuel temperature
C Radio frequency
D VOR station name
Answer: A. Aircraft flight path. Enhanced ground proximity systems use position and flight-path information with terrain databases to issue alerts.
Why keep independent navigation sources available on some operations?
A Improve cabin audio
B Reduce wing vibration
C Increase fuel pressure
D Provide reversion after failure
Answer: D. Provide reversion after failure. An independent source can preserve navigation capability if the primary system becomes unavailable.
What does an FMS alert when estimated accuracy exceeds required performance?
A Fuel imbalance
B Cabin altitude
C Navigation integrity loss
D Autopilot disconnect
Answer: C. Navigation integrity loss. If estimated navigation performance cannot meet the required value, the crew receives an alert.
How can dual air data computers reveal a sensor problem?
A Share one pitot line
B Compare their outputs
C Disable both displays
D Average radio signals
Answer: B. Compare their outputs. Comparing independent air-data solutions can expose disagreement that suggests a sensor or system fault.
A VOR radial combined with DME distance gives what kind of fix?
A Bearing-distance position
B Altitude-only report
C Runway glidepath
D Wind correction angle
Answer: A. Bearing-distance position. The radial supplies bearing and DME supplies distance, defining a bearing-distance position relative to the station.