Aerospace Manufacturing MCQs (Set-1)

Difficulty: Easy & Basic

What does additive manufacturing build parts from?

A Forged billets
B Cast ingots
C Layered material
D Cut sheet

What does CNC stand for?

A Controlled nitrogen cooling
B Computer numerical control
C Composite net casting
D Counterbore number chart

In casting, molten material is poured into what?

A Mold cavity
B Cutting tool
C Vacuum bag
D Rivet hole

What is the main action in forging?

A Layer deposition
B Chemical etching
C Ultrasonic testing
D Plastic deformation

Machining generally removes material from what?

A Prepreg ply
B Solid stock
C Molten pool
D Adhesive film

What does an autoclave control during composite curing?

A Fuel and oxygen
B Tool speed only
C Heat and pressure
D Radio frequency

Prepreg material consists of fibers combined with what?

A Metal powder
B Cutting fluid
C Ceramic grit
D Partially cured resin

Which fastener creates a permanent mechanical joint?

A Rivet
B Clevis pin
C Wing nut
D Quick-release latch

What is a manufacturing jig mainly used to do?

A Measure hardness
B Heat treat parts
C Guide tool position
D Remove surface oxide

What does a fixture primarily hold?

A Cure temperature
B Workpiece position
C Powder chemistry
D Inspection record

A dimensional tolerance defines what?

A Permitted variation
B Nominal material
C Surface color
D Tool rotation

Why are machined edges deburred?

A Increase hardness
B Add residual stress
C Seal fuel tanks
D Remove sharp burrs

What is the purpose of nondestructive testing?

A Measure fuel flow
B Change alloy temper
C Find flaws without damage
D Join composite plies

Liquid penetrant inspection finds which flaw type?

A Surface-breaking flaws
B Deep center voids
C Hidden delamination only
D Bulk chemistry changes

Which method commonly detects internal flaws using sound waves?

A Dye penetrant
B Ultrasonic testing
C Visual inspection
D Hardness testing

Radiographic inspection uses what to image internal structure?

A Magnetic fields
B Visible dye
C Water pressure
D X-rays

Eddy-current inspection is suited to which materials?

A All porous foams
B Uncured adhesives
C Electrical conductors
D Wood laminates

Why must measurement instruments be calibrated?

A Increase cutting speed
B Maintain measurement accuracy
C Change material strength
D Reduce part weight

What does manufacturing traceability link?

A Part to its records
B Tool to its color
C Cutter to its speed
D Fixture to floor

Why is a composite cure cycle recorded?

A Set tire pressure
B Calculate aircraft range
C Measure magnetic heading
D Verify process conditions

What is composite layup?

A Grinding an edge
B Placing reinforcement plies
C Casting a spar
D Turning a shaft

What does a honeycomb core mainly provide?

A Electrical conductivity
B Fuel containment
C Lightweight stiffness
D Magnetic shielding

Why is primer applied to prepared metal?

A Increase part thickness greatly
B Change alloy composition
C Remove machining chips
D Protect against corrosion

Why is backing often used when drilling composites?

A Limit exit damage
B Increase hole taper
C Raise resin temperature
D Reduce fiber count

What is the purpose of a final manufacturing inspection?

A Increase lift
B Set CG position
C Balance fuel
D Confirm conformity