Difficulty: Medium
What sets tsunami speed in the long-wave approximation?
A Gravity and water depth
B Wave height and salinity
C Wind speed and fetch
D Wave color and period
Answer: A. Gravity and water depth. Long-wave speed is approximately the square root of gravity times water depth.
A tsunami crosses 4,000-meter water. Its speed is near what?
A About 20 metres per second
B About 2 metres per second
C About 2,000 metres per second
D About 200 metres per second
Answer: D. About 200 metres per second. Using the shallow-water formula gives √(9.8 × 4,000), close to 200 metres per second.
If ocean depth becomes one-quarter, tsunami speed becomes what?
A About one-quarter
B About one-half
C About twice
D About fourfold
Answer: B. About one-half. Tsunami speed varies with the square root of depth.
As a tsunami enters shallower water, what happens to wavelength?
A It becomes shorter
B It becomes longer
C It stays fixed
D It becomes zero
Answer: A. It becomes shorter. Wave speed decreases while its period changes little, so wavelength shortens.
What commonly happens to tsunami height near shore?
A It vanishes
B It stays fixed
C It increases
D It becomes a ripple
Answer: C. It increases. Shoaling compresses tsunami energy into a shorter wavelength and can increase height.
Why does a tsunami act as a shallow-water wave offshore?
A Its height exceeds depth
B It is driven by wind
C It stays near surface
D Its wavelength greatly exceeds depth
Answer: D. Its wavelength greatly exceeds depth. A tsunami’s wavelength is much greater than ocean depth.
Why can a tsunami look small in deep water?
A Its wavelength is enormous
B It has no energy
C It moves only below
D Its period is seconds
Answer: A. Its wavelength is enormous. Long wavelengths allow a tsunami to carry energy with modest open-ocean height.
Which part of the ocean does a tsunami involve?
A Only the surface skin
B Nearly the full water column
C Only the seabed
D Only the thermocline
Answer: B. Nearly the full water column. A tsunami’s long wave motion extends from the sea surface toward the seabed.
Which tsunami wave is guaranteed to be largest?
A No particular arrival
B Always the first
C Always the second
D Always the last
Answer: A. No particular arrival. NOAA warns that the first arriving wave may not be the largest or most damaging.
What does a DART bottom-pressure recorder detect?
A Wind direction shifts
B Coral reef growth
C Surface color changes
D Pressure changes from waves
Answer: D. Pressure changes from waves. A DART recorder detects small pressure changes caused by passing tsunami waves.
What information chiefly determines NOAA tsunami travel-time maps?
A Wave color
B Coastal population
C Ocean depth
D Wind direction
Answer: C. Ocean depth. Long-wave speed depends on depth, so bathymetry is central to travel-time estimates.
What causes wave refraction over uneven depth?
A Uneven wave speeds
B Salinity becomes uniform
C Tides stop moving
D Uneven wave speeds
Answer: D. Uneven wave speeds. Depth variation changes wave speed along a crest, bending the wave path.
One end of a crest enters shallower water. What happens there?
A That end slows first
B That end speeds up
C The crest disappears
D The period doubles
Answer: A. That end slows first. The shallow end slows, causing the crest to pivot as refraction proceeds.
What can converging wave rays over bathymetry cause?
A Uniform wave heights
B Local wave amplification
C Lower tidal range
D Reduced water density
Answer: B. Local wave amplification. Converging rays focus wave energy into a smaller coastal area.
What can diverging wave rays produce?
A Greater local focusing
B A new tsunami source
C Lower local wave energy
D Higher ocean salinity
Answer: C. Lower local wave energy. Diverging rays spread wave energy across a wider area.
When is a wave considered deep-water?
A Depth is below one metre
B Depth exceeds half wavelength
C Height exceeds wavelength
D Period exceeds one minute
Answer: B. Depth exceeds half wavelength. Deep-water waves do not significantly feel the seabed when depth exceeds about half a wavelength.
What influence do shallow-water waves strongly feel?
A Only surface tension
B Only lunar gravity
C Atmospheric pressure alone
D Seafloor bottom effects
Answer: D. Seafloor bottom effects. Shallow-water waves interact with the seabed and their speed depends strongly on depth.
How does water-particle motion change as waves shoal?
A Orbits grow circular
B Orbits become flatter
C Particles stop moving
D Motion shifts upward only
Answer: B. Orbits become flatter. Bottom interaction flattens the orbital paths of water particles.
What does wave setup mean near a beach?
A A sudden tidal fall
B A deep-ocean current
C Mean water-level rise
D A wave spectrum peak
Answer: C. Mean water-level rise. Breaking waves can raise the mean water level in the surf zone.
A common limiting breaker index compares what?
A Wave period with fetch
B Wave height with depth
C Salinity with temperature
D Wavelength with wind speed
Answer: B. Wave height with depth. A common empirical index relates breaking wave height to local water depth.
During shoaling across fixed bathymetry, what usually stays nearly constant?
A Wave period
B Wave height
C Wavelength
D Wave speed
Answer: A. Wave period. For a stationary seabed, frequency is conserved as the wave shoals.
In 9-meter shallow water, long-wave speed is about what?
A 3 metres per second
B 30 metres per second
C 9.4 metres per second
D 94 metres per second
Answer: C. 9.4 metres per second. The estimate √(9.8 × 9) is about 9.4 metres per second.
In shallow water, wave speed depends mainly on what?
A Water depth
B Wave period alone
C Wave height alone
D Wind direction
Answer: A. Water depth. Long-wave speed is approximately √(g times depth), independent of period.
Near a straight coast, refraction tends to align crests how?
A Perpendicular to shore
B Toward the open ocean
C Parallel to shore
D At random angles
Answer: C. Parallel to shore. As the nearshore part slows, wave crests tend to align more parallel with the coast.
Why can tsunamis cross entire ocean basins?
A They are pushed by tides
B They break continuously
C They ride ocean currents only
D Long waves lose energy slowly
Answer: D. Long waves lose energy slowly. Very long waves can propagate great distances with relatively little energy loss.