Highway Engineering MCQs (Set-1)

Highway engineering deals mainly with planning, design and what?

A Treatment of sewage
B Operation of roads
C Casting of beams
D Mining of coal

Highway alignment describes what?

A Pavement color
B Road centreline position
C Traffic signal timing
D Bridge bearing type

A highway cross-section is viewed in which direction?

A Along the route
B From a satellite
C Across the road
D Through a bridge pier

Camber is provided mainly to do what?

A Increase axle load
B Reduce sight distance
C Drain surface water
D Support bridge bearings

Superelevation raises the outer edge on what road feature?

A Straight level tangent
B Horizontal curve
C Culvert barrel
D Bridge abutment

Stopping sight distance includes reaction distance and what?

A Overtaking distance
B Braking distance
C Parking distance
D Signal cycle time

A horizontal curve changes which alignment component?

A Road elevation only
B Pavement thickness
C Direction in plan
D Drainage outlet size

A transition curve gradually introduces what?

A Pavement joints
B Roadside parking
C Traffic signals
D Curvature and superelevation

A vertical curve connects which road elements?

A Different gradients
B Two traffic lanes
C Separate pavements
D Drainage channels

A road gradient is the rate of change in what?

A Elevation along distance
B Width across the road
C Traffic volume per hour
D Pavement density

Right-of-way is land reserved for what?

A Highway and related uses
B Parking meters only
C A single traffic sign
D One drainage grate

Flexible pavement commonly uses which bound surface material?

A Plain brick only
B Bituminous mixture
C Timber planks
D Unbound clay

Rigid pavement commonly uses which slab material?

A Loose gravel only
B Bitumen emulsion only
C Portland cement concrete
D Compacted silt

The subgrade is which pavement component?

A Top wearing layer
B Roadside drain
C Traffic island
D Prepared soil foundation

A pavement base course lies below which layer?

A Natural water table
B Surface course
C Bridge deck
D Roadside curb

The wearing course directly faces what?

A Traffic and weather
B Foundation piles
C Underground utilities
D Bridge bearings

A shoulder is located where relative to the carriageway?

A At the road centreline
B Under the subgrade
C Inside the median only
D Along its outer edge

Pavement drainage helps prevent what?

A Vehicle registration
B Signal conflict
C Road alignment error
D Water-related damage

CBR is an empirical measure of what?

A Subgrade strength
B Bitumen viscosity
C Concrete slump
D Traffic signal delay

Traffic signs communicate rules, warnings and what?

A Soil density
B Pavement thickness
C Guidance information
D Bridge reactions

Longitudinal road markings generally run in which direction?

A Across the pavement only
B Vertically on signs
C Along the road
D Below the subgrade

A guardrail is intended to do what?

A Contain errant vehicles
B Increase pavement friction
C Drain groundwater
D Mark a bus stop

Access control limits what along a highway?

A Design speed
B Pavement drainage
C Vehicle axle loads
D Direct property access

Routine road maintenance can include what?

A Trip generation modeling
B Pile load testing
C Water chlorination
D Pothole patching

A highway route survey helps determine what?

A Feasible road corridor
B Concrete curing rate
C Signal lamp voltage
D Soil mineral formula