Aircraft Materials MCQs (Set-2)

Difficulty: Easy & Basic

What does isotropic behavior mean?

A Properties vary by axis
B Only one fiber direction
C Properties match all directions
D No elastic response

Why do laminate ply angles matter?

A They change fuel grade
B They set directional stiffness
C They reduce air pressure
D They set metal density

Orthotropic properties vary along how many principal axes?

A One
B Two
C Four
D Three

Why align fibers with a major load?

A To carry load efficiently
B To prevent all heating
C To reduce inspection
D To increase corrosion

Fatigue cracks often begin near what feature?

A Smooth broad surface
B Low density core
C Stress concentration
D Paint color

What does an S-N curve relate?

A Stress amplitude and cycles
B Density and temperature
C Load and area only
D Hardness and color

Fracture toughness measures resistance to what?

A Elastic recovery
B Crack growth
C Thermal expansion
D Surface polishing

Ultrasonic inspection sends which energy through a part?

A Visible light
B Direct current
C X-ray film
D High-frequency sound

A coin-tap test can indicate what composite damage?

A Metal hardness
B Fuel contamination
C Disbond or delamination
D Paint thickness

Eddy-current inspection works best on what?

A Electrically conductive material
B Dry wood only
C Clear glass
D Foam core only

Radiographic inspection reveals internal changes in what?

A Surface color
B Material attenuation
C Magnetic north
D Elastic modulus only

Dye penetrant detects which flaw type?

A Deep closed cracks
B Bulk density only
C Temperature gradients
D Surface-breaking flaws

How can a metal joint limit galvanic attack?

A Add salt water
B Remove all coatings
C Use an insulating barrier
D Increase metal contact

Stress-corrosion cracking combines tensile stress with what?

A Low lighting
B A susceptible environment
C High density
D Pure vacuum only

Miner’s rule estimates cumulative fatigue damage by summing what?

A Cycle fractions
B Elastic moduli
C Temper codes
D Surface areas

Different thermal expansion rates can cause what at a joint?

A Fuel atomization
B Lower air density
C Thermal stress
D Zero strain

What is the function of Alclad on some aluminum alloys?

A A composite core
B A steel fastener
C A thermal sensor
D Corrosion-resistant cladding

An aluminum temper designation identifies what?

A Wing station
B Material condition
C Fuel type
D Fastener diameter

Cold working generally changes metal strength how?

A Raises strength, lowers ductility
B Lowers strength, raises ductility
C Removes all residual stress
D Leaves properties unchanged

Shot peening improves fatigue resistance by creating what?

A Core melting
B Tensile surface stress
C Lower alloy content
D Surface compression

Why can composite impact damage be difficult to see?

A Fibers dissolve instantly
B Paint always hides cracks
C Damage may be internal
D Composites cannot crack

In a sandwich panel, what does the core chiefly do?

A Separates and stabilizes skins
B Carries fuel
C Forms the paint layer
D Replaces every fastener

Delamination most directly weakens which laminate property?

A Metal conductivity
B Interlaminar integrity
C Surface hardness
D Fuel resistance

Fiber volume fraction measures fiber volume relative to what?

A Matrix mass
B Panel length
C Ply angle
D Total composite volume

Why combine 0-degree and 90-degree plies?

A To eliminate the matrix
B To support multiple directions
C To prevent all fatigue
D To reduce fiber strength