The same net force accelerates a lighter vehicle how?
A More quickly
B More slowly
C At zero acceleration
D Only sideways
Answer: A. More quickly. Newton’s second law gives acceleration as force divided by mass.
How does wheel torque create forward tire force?
A Torque times wheelbase
B Mass divided by speed
C Pressure times track
D Torque divided by tire radius
Answer: D. Torque divided by tire radius. At the contact patch, longitudinal force is approximately wheel torque divided by rolling radius.
What mainly causes tire rolling resistance?
A Air pressure alone
B Wheelbase length
C Steering angle
D Tire deformation
Answer: D. Tire deformation. Repeated deformation of the tire and road surface dissipates energy as a rolling-resistance force.
At constant air density, drag force rises with what?
A Speed squared
B Speed only
C Mass squared
D Wheelbase
Answer: A. Speed squared. Aerodynamic drag is proportional to the square of relative air speed when other factors remain constant.
At constant conditions, aerodynamic power demand rises roughly with what?
A Speed squared
B Speed only
C Speed cubed
D Inverse speed
Answer: C. Speed cubed. Since drag grows with speed squared, power needed to overcome it grows approximately with speed cubed.
Why does an uphill road require extra tractive force?
A Gravity acts against motion
B Tire radius increases
C Yaw inertia disappears
D Air density falls
Answer: A. Gravity acts against motion. A component of vehicle weight acts down the slope and must be overcome during uphill travel.
Hard braking shifts normal load mainly where?
A Toward the rear
B Only to the left
C Only to the right
D Toward the front
Answer: D. Toward the front. The deceleration moment transfers normal load from rear wheels toward the front axle.
Which relation gives lateral acceleration in a steady turn?
A Radius over speed
B Mass times wheelbase
C Speed squared over radius
D Yaw rate over mass
Answer: C. Speed squared over radius. For circular motion, lateral acceleration is v²/R.
At the same speed, a smaller turn radius produces what?
A Lower lateral acceleration
B Zero yaw rate
C Greater lateral acceleration
D Less tire force
Answer: C. Greater lateral acceleration. Because lateral acceleration is v²/R, reducing radius increases the required acceleration.
At the same radius, doubling speed changes lateral acceleration by what factor?
A Two times
B Four times
C Half
D No change
Answer: B. Four times. Lateral acceleration varies with speed squared, so doubling speed multiplies it by four.
For the same mass and turn, what reduces lateral load transfer?
A Higher center of gravity
B Narrower track
C Lower center of gravity
D Greater lateral acceleration
Answer: C. Lower center of gravity. Lowering the center of gravity reduces the overturning moment that transfers load across the track.
Why does wider track generally reduce lateral load transfer?
A It raises vehicle mass
B It increases the support span
C It reduces tire friction
D It increases yaw inertia
Answer: B. It increases the support span. For a given lateral force and center-of-gravity height, a wider track reduces the load difference between sides.
What does tire load sensitivity mean?
A Grip doubles with load
B Grip rises less than load
C Grip ignores normal load
D Grip depends only on speed
Answer: B. Grip rises less than load. Many tires generate less total force per unit load as vertical load increases.
The friction circle represents what?
A Combined tire-force capacity
B Wheelbase geometry
C Engine torque curve
D Suspension travel
Answer: A. Combined tire-force capacity. The friction circle illustrates that longitudinal and lateral tire forces share limited available adhesion.
A tire brakes while cornering. What happens to available cornering force?
A It is reduced
B It becomes unlimited
C It doubles
D It stays independent
Answer: A. It is reduced. Braking uses part of the tire’s force capacity, leaving less for lateral cornering force.
Braking slip ratio compares wheel speed with what?
A Vehicle speed
B Engine speed
C Steering rate
D Suspension frequency
Answer: A. Vehicle speed. Braking slip ratio relates tire peripheral speed to vehicle forward speed.
What does traction control limit during hard acceleration?
A Body pitch only
B Excessive wheel spin
C Steering angle
D Brake temperature
Answer: B. Excessive wheel spin. Traction control reduces drive torque or applies brakes when driven wheels spin excessively.
A vehicle has reached steady-state cornering when what is nearly constant?
A Brake-pad temperature
B Fuel level
C Speed and turning response
D Road roughness
Answer: C. Speed and turning response. Steady-state cornering describes a settled turn with approximately constant speed, radius, and response.
What describes transient response when entering a turn?
A Constant straight travel
B Battery charging
C Short-term changing motion
D Static ride height
Answer: C. Short-term changing motion. Transient response covers the time-dependent changes in yaw, lateral acceleration, and body motion.
In a steady circular turn, yaw rate equals what?
A Radius divided by speed
B Mass divided by force
C Track divided by wheelbase
D Speed divided by radius
Answer: D. Speed divided by radius. For a steady turn, yaw rate r equals forward speed divided by turn radius.
A vehicle needs more steering as speed rises in a fixed-radius turn. What tendency is present?
A Oversteer
B Neutral steer
C Wheel hop
D Understeer
Answer: D. Understeer. An understeering vehicle needs additional steering angle as lateral demand rises.
Which design change generally raises rigid-body rollover threshold?
A Higher center of gravity
B Narrower track
C Higher roof mass
D Lower center of gravity
Answer: D. Lower center of gravity. Lowering mass height reduces roll moment and raises the lateral acceleration needed to lift wheels.
A strong crosswind primarily adds which disturbance?
A Longitudinal grade force
B Lateral force
C Brake torque
D Spring preload
Answer: B. Lateral force. Crosswind pressure on the body can create side force and yawing disturbance.
Why can a sudden lane change raise rollover risk?
A Lower tire pressure always
B Reduced yaw inertia
C Lower road speed
D Rapid lateral load transfer
Answer: D. Rapid lateral load transfer. A rapid maneuver can move load outward quickly and may lift inner wheels in a high-CG vehicle.
Which tires carry more normal load during a steady turn?
A Inside tires
B Outside tires
C Only front tires
D Only rear tires
Answer: B. Outside tires. Cornering load transfer increases normal load on the outside wheels and reduces it on the inside wheels.