Surface Chemistry MCQs Set-4

Difficulty: Hard

For Freundlich adsorption, x/m=K P^(1/2). If K=2.0 mg g⁻¹ bar⁻¹/² and P=9.0 bar, x/m is

A 18 mg g⁻¹
B 2.0 mg g⁻¹
C 3.0 mg g⁻¹
D 6.0 mg g⁻¹

For x/m=K P^(1/2), increasing pressure from 4 bar to 36 bar changes x/m by a factor of

A 3
B 9
C 6
D 1/3

A Freundlich plot gives slope 0.40 for log(x/m) versus log P. The value of n is

A 0.40
B 2.5
C 1.4
D 4.0

For the Langmuir model θ=KP/(1+KP), if K=0.50 bar⁻¹ and P=4.0 bar, fractional surface coverage is

A 1/3
B 1/2
C 2/3
D 0.80

For Langmuir adsorption with K=2.0 L mol⁻¹ and C=0.50 mol L⁻¹, θ=KC/(1+KC) is

A 0.25
B 0.75
C 1.0
D 0.50

An adsorbent mass of 10.0 g retains 1.50 g adsorbate. The loading x/m is

A 0.150 g g⁻¹
B 6.67 g g⁻¹
C 1.50 g g⁻¹
D 0.0150 g g⁻¹

A 2.0 g adsorbent removes 60% of 5.0 g solute from solution. Adsorbed mass is

A 2.0 g
B 3.0 g
C 1.2 g
D 4.0 g

If 3.0 g adsorbate is retained by 2.0 g adsorbent, x/m equals

A 0.67 g g⁻¹
B 6.0 g g⁻¹
C 1.5 g g⁻¹
D 0.15 g g⁻¹

A negatively charged sol is coagulated by an electrolyte providing Al³⁺ and Na⁺ at equal concentration. Under the Hardy–Schulze rule, the stronger coagulant is

A Na⁺
B both equally
C neither ion
D Al³⁺

A positively charged sol is coagulated more effectively by PO₄³⁻ than by Cl⁻ because PO₄³⁻ has

A larger opposite charge
B same charge sign
C lower valence
D greater molecular size only

A 1:1 electrolyte is added to a lyophobic sol. If its concentration is increased, coagulation generally becomes more likely because

A particles gain a permanent solvent shell
B electrostatic repulsion is screened
C the sol becomes a true solution
D the Tyndall effect creates particles

An aqueous sol has particles with radius 50 nm. Their diameter is

A 50 nm
B 25 nm
C 100 nm
D 500 nm

A 0.20 g protective colloid is sufficient for a standard test, while another needs 0.80 g. The first has a gold number that is

A four times larger
B equal
C independent of amount
D four times smaller

If gas pressure is multiplied by 16 and Freundlich exponent 1/n=0.25, x/m changes by a factor of

A 2
B 4
C 8
D 16

For x/m=K P^(1/3), if pressure is multiplied by 8, x/m changes by a factor of

A 4
B 2
C 8
D 1/2

A colloid has a Tyndall beam path visible in a dark room. This observation supports that the dispersion

A is a pure molecular solution
B contains no dispersed phase
C scatters light as colloidal particles
D is necessarily an emulsion

For a negatively charged sol, electrophoretic migration is toward the

A negative electrode
B neutral wall
C salt bridge only
D positive electrode

An emulsion contains oil droplets dispersed in water. Its type is

A oil-in-water
B water-in-oil
C solid-in-liquid
D gas-in-liquid

A micellar solution forms when surfactant concentration exceeds the

A freezing-point depression
B critical micelle concentration
C Kf value
D osmotic-pressure threshold

If the limiting surface coverage in a Langmuir model is 1 and θ=0.80, the fraction of unoccupied sites is

A 0.80
B 1.80
C 0.20
D 0

For Langmuir adsorption, at very low pressure KP≪1, θ is approximately

A 1
B 1/KP
C P²K
D KP

For Langmuir adsorption, at very high pressure KP≫1, θ approaches

A 1
B 0
C KP
D 1/KP

The adsorption of a gas on a solid releases 20 kJ mol⁻¹. The enthalpy change is

A +20 kJ mol⁻¹
B −20 kJ mol⁻¹
C 0 kJ mol⁻¹
D −40 kJ mol⁻¹

If adsorption is exothermic, increasing temperature generally shifts the equilibrium toward

A greater adsorption
B no change in coverage
C desorption
D colloid formation

A catalyst surface has 0.80 fractional occupancy by adsorbed reactant. If surface sites are either occupied or free, the free fraction is

A 0.80
B 1.25
C 0.40
D 0.20