For Freundlich adsorption, a plot of log(x/m) against log P has slope
A logK
B n
C 1/n
D K
Answer: C. 1/n. The log-linear form is log(x/m)=logK+(1/n)logP.
If x/m doubles when pressure rises from 1 to 4 units, the Freundlich exponent 1/n is
A 0.25
B 1.0
C 2.0
D 0.50
Answer: D. 0.50. 2=(4/1)^(1/n), so 1/n=log2/log4=0.50.
A gas that is more easily liquefied is often adsorbed more strongly because it
A has stronger intermolecular attraction and higher critical temperature
B has lower molecular mass in every case
C cannot diffuse
D is always chemically bonded to the surface
Answer: A. has stronger intermolecular attraction and higher critical temperature. More condensable gases generally have stronger attraction to a solid surface and are more readily adsorbed.
For a fixed gas and solid, increasing the solid’s porosity generally
A decreases surface area to zero
B increases available adsorption area
C prevents adsorption
D changes gas into a liquid
Answer: B. increases available adsorption area. Porosity often exposes more internal surface area for adsorption.
Adsorption of a gas on a solid commonly decreases as temperature rises because adsorption is usually
A endothermic
B independent of enthalpy
C exothermic
D a nuclear process
Answer: C. exothermic. Higher temperature favors desorption for an exothermic adsorption equilibrium.
If adsorption is exothermic, lowering temperature at fixed pressure generally
A favors desorption
B has no effect on equilibrium
C causes coagulation
D favors adsorption
Answer: D. favors adsorption. Lower temperature shifts an exothermic adsorption equilibrium toward adsorbed species.
A negatively charged colloidal particle moves toward the ___ during electrophoresis
A anode
B cathode
C salt bridge
D neutral electrode only
Answer: A. anode. A negative particle is attracted to the positive anode.
A positively charged colloidal particle moves toward the
A anode
B cathode
C positive terminal
D neutral solution
Answer: B. cathode. A positive particle migrates toward the negative cathode.
Arsenic sulfide sol is typically negatively charged. Its coagulation is especially effective with
A Na⁺
B Cl⁻
C Al³⁺
D SO₄²⁻
Answer: C. Al³⁺. Al³⁺ is a high-valence counterion to the negatively charged sol.
For a positively charged ferric hydroxide sol, an effective coagulating ion is
A Al³⁺
B Na⁺
C Ca²⁺
D PO₄³⁻
Answer: D. PO₄³⁻. A highly charged anion is an effective counterion for a positive sol.
Mixing equal amounts of oppositely charged sols can cause
A coagulation
B enhanced stabilization in every case
C formation of a true solution
D gas adsorption
Answer: A. coagulation. Oppositely charged colloidal particles neutralize one another and may aggregate.
The Tyndall effect is generally absent in a true solution because its solute particles
A are always uncharged
B are too small to scatter visible light appreciably
C have no mass
D are larger than colloids
Answer: B. are too small to scatter visible light appreciably. Molecular or ionic solutes are too small for strong visible-light scattering.
Brownian motion helps stabilize a colloid by
A increasing particle size
B neutralizing all surface charge
C opposing settling under gravity
D forming a precipitate
Answer: C. opposing settling under gravity. Random thermal motion counteracts sedimentation of sufficiently small particles.
The dialysis membrane removes small ions from a sol while retaining colloidal particles because of the difference in
A colour
B density only
C electrical conductivity
D particle size
Answer: D. particle size. Small ions pass through the membrane pores, but colloidal particles are retained.
Peptization is often caused by adsorption of
A one ion from an added electrolyte on precipitate particles
B all solvent molecules on the filter
C neutral gas molecules only
D a catalyst poison
Answer: A. one ion from an added electrolyte on precipitate particles. Selective ion adsorption can impart charge and disperse a precipitate into a sol.
For a negative sol, Al³⁺ is generally more effective as a coagulant than Na⁺ because Al³⁺ has
A lower atomic mass
B higher counterion valence
C the same charge sign
D greater solubility only
Answer: B. higher counterion valence. The Hardy–Schulze rule links greater counterion charge to stronger coagulating power.
In Freundlich’s equation, if 1/n is less than 1, increasing pressure by a factor of 9 changes x/m by a factor of
A 1/9^(1/n)
B 9n
C 9^(1/n)
D n/9
Answer: C. 9^(1/n). The adsorption ratio follows the pressure ratio raised to the Freundlich exponent.
A catalyst poison reduces catalytic activity primarily by
A increasing reactant concentration
B raising equilibrium constant
C increasing surface roughness only
D occupying or altering active sites
Answer: D. occupying or altering active sites. Poison molecules block sites needed for reactant adsorption or reaction.
In heterogeneous catalysis, adsorption can increase reaction rate by
A concentrating reactants at the catalyst surface
B changing the equilibrium constant
C raising product activation energy
D removing all reactants from contact
Answer: A. concentrating reactants at the catalyst surface. Surface concentration and activation-barrier lowering can accelerate reaction.
An enzyme’s high selectivity is often explained by
A its high molar mass alone
B a complementary active site for particular substrates
C its ability to change equilibrium
D its lack of surface interactions
Answer: B. a complementary active site for particular substrates. Substrate binding depends on the enzyme’s specific active-site structure and interactions.
A hydrophilic colloid is usually easier to prepare and more stable because it has
A no interaction with the medium
B only covalent particles
C strong affinity for the dispersion medium
D a large net mass
Answer: C. strong affinity for the dispersion medium. Strong solvation stabilizes lyophilic colloidal particles.
A protective colloid stabilizes a lyophobic sol mainly by
A increasing electrolyte concentration
B removing the dispersion medium
C making all particles oppositely charged
D forming a solvated protective layer around particles
Answer: D. forming a solvated protective layer around particles. A protective lyophilic layer hinders aggregation and coagulation.
A low gold number indicates that the colloid has
A high protective power
B low protective power
C high coagulating power
D large particle size
Answer: A. high protective power. A smaller amount needed to protect the standard gold sol means stronger protective action.
A 1:1 electrolyte added to a colloid can cause coagulation when its counterions
A increase the sol’s mass only
B reduce particle charge sufficiently
C all have the same sign as the particles
D evaporate
Answer: B. reduce particle charge sufficiently. Counterion adsorption can reduce the electrostatic repulsion that stabilizes a sol.
A sol is best described as a colloid with a dispersed phase that is
A liquid in gas only
B gas in gas
C solid and a dispersion medium that is liquid
D solid in solid only
Answer: C. solid and a dispersion medium that is liquid. A sol is a colloidal dispersion of solid particles in a liquid medium.