Difficulty: Hard
A road cut removes the toe of a steep slope before intense rain. Which changes most increase failure risk?
A More roots, drier soil
B Lower relief, stronger rock
C Less runoff, more cover
D Less toe support, wetter soil
Answer: D. Less toe support, wetter soil. Removing toe support and adding water can reduce slope stability.
A saturated reservoir bank fails soon after a rapid drawdown. Which change is the key trigger?
A Increased root strength
B Reduced external water support
C Lower channel gradient
D Less pore pressure
Answer: B. Reduced external water support. Rapid drawdown can remove water-side support before internal pore pressures dissipate.
A bare semiarid hillside receives a cloudburst. Which surface processes are likely?
A Glacial plucking
B Tidal abrasion
C Sheetwash and rilling
D Coral deposition
Answer: C. Sheetwash and rilling. Sparse cover and intense runoff can produce sheetwash and rills.
A saturated sediment mass rotates on a curved slip surface. Classify it as:
A Rotational slump
B Translational slide
C Rockfall
D Debris creep
Answer: A. Rotational slump. Rotation on a curved surface identifies a slump.
A water-rich mixture of mud and coarse clasts moves downslope. It is a:
A Rockfall
B Translational slide
C Topple
D Debris flow
Answer: D. Debris flow. Debris flows carry coarse fragments within a fluid-rich mixture.
A block moves over a planar bedding surface with little rotation. This is a:
A Rotational slump
B Rockfall
C Translational slide
D Earthflow
Answer: C. Translational slide. A slide commonly follows a planar weakness surface.
During an earthquake, intact soil blocks shift laterally above liquefied sediment. This is a:
A Rockfall
B Lateral spread
C Rotational slump
D Debris flow
Answer: B. Lateral spread. Liquefaction beneath a relatively coherent surface layer can produce lateral spreading.
One landslide starts as a slump and changes downslope into a flow. It is a:
A Complex landslide
B Rockfall
C Translational slide
D Topple
Answer: A. Complex landslide. A landslide combining more than one movement type is classified as complex.
A convex crest, straight midslope, and concave toe together describe a:
A River terrace
B Drainage divide
C Slope profile
D Coastal sequence
Answer: C. Slope profile. These connected units make up a hillslope profile.
Two equal-angle hillslopes face different directions. Their most direct microclimatic contrast is:
A Rock age
B Relief only
C Channel order
D Solar exposure
Answer: D. Solar exposure. Aspect affects solar radiation and can create different hillslope energy and moisture conditions.
A steep bare face sheds blocks along joints. The dominant process is:
A Rockfall
B Soil creep
C Sheetwash
D Rotational sliding
Answer: A. Rockfall. Jointed rock can detach and fall from a steep face.
A resistant cap over weak layers can maintain a:
A Broad floodplain
B Steep rock face
C Gentle dune
D Tidal flat
Answer: B. Steep rock face. Differential resistance can preserve steep faces above weaker units.
A hillside rises 30 m over 60 m horizontally. What is percent gradient?
A 30%
B 50%
C 60%
D 90%
Answer: B. 50%. Percent gradient is rise divided by horizontal distance, times one hundred.
Coalescing pediments left by parallel scarp retreat produce a:
A Pediplain
B Peneplain
C Floodplain
D Drumlin
Answer: A. Pediplain. King used pediplain for a broad surface formed as pediments coalesce during scarp retreat.
A measured profile shows an abrupt change in gradient between two segments. The boundary is a:
A Drainage divide
B Channel thalweg
C Break of slope
D River terrace
Answer: C. Break of slope. A break of slope marks an abrupt change in gradient along a profile.
In Davis’s cycle, the broad low-relief surface at the end is a:
A Pediplain
B Alluvial fan
C Glacial trough
D Peneplain
Answer: D. Peneplain. Davis used peneplain for the low-relief surface produced late in the idealized erosion cycle.
A loose gravel pile steepens until particles begin sliding. The threshold angle is its:
A Angle of repose
B Slope aspect
C Channel gradient
D Base level
Answer: A. Angle of repose. The angle of repose is the limiting stable angle of loose granular material.
A saturated, fine-grained slope mass forms an elongated, deforming tongue. Classify it as an:
A Rockfall
B Earthflow
C Topple
D Translational slide
Answer: B. Earthflow. Earthflows commonly deform plastically and occur in fine-grained saturated material.
Rain infiltrates loose soil and pore pressure rises. Effective stress generally:
A Increases sharply
B Stays unrelated
C Becomes zero always
D Decreases
Answer: D. Decreases. Rising pore pressure can reduce effective stress and stability.
A free face is gradually buried when debris at its base:
A Moves upslope
B Turns into bedrock
C Accumulates faster than removed
D Is carried by tides
Answer: C. Accumulates faster than removed. Accumulating scree can progressively bury a free face.
A landform model should be applied cautiously because slope form also depends on:
A Climate, rock, and tectonics
B Map color and font
C River names only
D Latitude alone
Answer: A. Climate, rock, and tectonics. Slope evolution reflects interacting climate, lithology, and tectonics.
Two slopes with similar profiles can have:
A Identical rock ages
B The same failure date
C No vegetation
D Different process histories
Answer: D. Different process histories. Similar forms can result from different processes and histories.
Resisting shear strength is 36 kPa and driving shear stress is 24 kPa. The simplified factor of safety is:
A 0.67
B 12
C 1.5
D 60
Answer: C. 1.5. For this simplified comparison, factor of safety equals resisting strength divided by driving stress: 36 / 24 = 1.5.
An eroded, gently sloping bedrock surface at an arid mountain front is a:
A Pediplain
B Pediment
C Peneplain
D Alluvial fan
Answer: B. Pediment. A pediment is an erosional rock surface at a mountain front; coalescing pediments may form a pediplain.
A rapid uplift pulse can steepen slopes before denudation fully adjusts. The landscape is:
A Transient
B Fully graded
C At base level
D Completely inactive
Answer: A. Transient. Rapid uplift can leave slopes temporarily out of balance.