Power System Protection MCQs (Set-2)

Which fault connects one phase conductor to earth?

A Line-to-line fault
B Three-phase fault
C Single-line-to-ground fault
D Open-phase condition

Which fault directly connects two phase conductors?

A Single-line-to-ground fault
B Three-phase-to-ground fault
C Open-circuit fault
D Line-to-line fault

Which short circuit involves all three phases?

A Three-phase fault
B Single-line fault
C Line-to-line fault
D Open-conductor fault

A balanced three-phase fault has what phase relationship?

A Equal phase magnitudes
B Only one phase current
C Zero current in two phases
D Unequal phase angles

Which sequence component appears in an unbalanced fault?

A Positive sequence only
B No sequence component
C Frequency sequence
D Negative sequence

Which fault type may clear itself after a brief arc?

A Permanent cable failure
B Winding short circuit
C Broken busbar joint
D Transient line fault

What is the basic purpose of automatic reclosing?

A Raise the line voltage
B Restore service after transient faults
C Change relay pickup
D Balance transformer phases

Which protection device is common on a small branch circuit?

A Distance relay
B Bus differential relay
C Generator synchronizer
D Fuse link

In an inverse-time relay, what happens as fault current rises?

A Operating time increases
B Operating time decreases
C Pickup current disappears
D Breaker rating doubles

What does an instantaneous overcurrent element add?

A A fixed voltage boost
B A directional channel
C No intentional time delay
D A thermal reset heater

A definite-time overcurrent element operates after what?

A A delay that shrinks continuously
B A frequency reversal
C A manual reset only
D Set delay above pickup

Why use directional overcurrent protection on a ring feeder?

A Measure transformer oil level
B Distinguish fault direction
C Synchronize two generators
D Limit charging current

A residual-current element commonly measures what?

A Average phase voltage
B Sum of phase currents
C Positive-sequence power
D Breaker travel time

A core-balance CT surrounds which conductors?

A Only the neutral bar
B The breaker trip coil
C One phase and earth
D All phase conductors

What does a relay current setting establish?

A Pickup threshold
B Breaker contact gap
C CT insulation class
D Busbar thermal limit

What does a time-multiplier setting adjust?

A CT transformation ratio
B VT polarity
C Relay operating delay
D Breaker interrupting capacity

Why coordinate an upstream relay with a downstream fuse?

A Make both trip together
B Raise feeder voltage
C Local device clears first
D Increase fault duration

An isolator is normally operated after what condition?

A A fault is being cleared
B Breaker carries fault current
C Current is interrupted
D A relay measures impedance

What is the role of an earthing switch?

A Ground isolated equipment
B Interrupt full fault current
C Measure residual current
D Adjust relay timing

What does an arc chute help a low-voltage breaker do?

A Measure load frequency
B Prevent relay pickup
C Extinguish contact arcs
D Cool transformer oil

A low-voltage circuit breaker may combine which trip mechanisms?

A Thermal and magnetic
B Hydraulic and optical
C Chemical and acoustic
D Speed and torque

What does an undervoltage relay monitor?

A Voltage below a setting
B Current above a setting
C Power-flow direction
D Winding temperature

What is a surge arrester designed to limit?

A Sustained overload current
B Transient overvoltage
C Power-frequency drift
D Breaker opening time

What can a transformer Buchholz relay detect?

A Line distance to fault
B Gas or oil-flow changes
C Generator reverse power
D Busbar phase sequence

Why supervise a breaker trip circuit?

A Detect loss of trip readiness
B Increase the CT ratio
C Measure line charging power
D Control generator speed