A sandstone bed is overlain by shale, and neither has been overturned. Which bed is older?
A The shale above
B Both are necessarily the same age
C The sandstone below
D The younger bed cannot be identified
Answer: C. The sandstone below. Superposition indicates that the underlying sandstone was deposited before the shale above it.
A basalt dike cuts shale and sandstone, then is overlain by an unbroken limestone bed. Which sequence is correct?
A Dike intrusion, limestone, then shale and sandstone
B Limestone, dike intrusion, then older beds
C All units formed simultaneously
D Shale and sandstone, dike intrusion, then limestone
Answer: D. Shale and sandstone, dike intrusion, then limestone. The dike is younger than the rocks it cuts but older than the limestone deposited across it.
A granite body contains fragments of sandstone, and the sandstone layers are cut by the granite. What does each relationship indicate?
A The sandstone fragments and beds are older than the granite
B The granite is older than the sandstone it cuts
C The fragments formed after the granite
D The ages cannot be ordered
Answer: A. The sandstone fragments and beds are older than the granite. Both inclusions and cross-cutting relations indicate that the sandstone predates the granite intrusion.
Older tilted beds are truncated beneath younger horizontal beds. Which unconformity is most likely?
A Disconformity
B Angular unconformity
C Nonconformity
D No unconformity
Answer: B. Angular unconformity. An angular unconformity separates older deformed strata from younger strata deposited at a different orientation.
Parallel sedimentary beds are separated by an irregular erosional surface. Which interpretation is best?
A A nonconformity between sediment and granite
B A continuous depositional boundary with no interruption
C A disconformity with a time gap
D A strike-slip fault
Answer: C. A disconformity with a time gap. A disconformity commonly separates roughly parallel sedimentary strata across an erosional or nondepositional gap.
Sandstone rests directly on an eroded granite surface. What contact is represented?
A An angular unconformity
B A conformable contact
C A thrust fault
D A nonconformity
Answer: D. A nonconformity. Sedimentary rock over eroded igneous rock defines a nonconformity.
A fossil species is abundant, easy to identify, geographically widespread, and lasted only a short time. Why is it valuable?
A It is an effective index fossil for correlation
B It gives the exact thickness of the formation
C It measures the age of a fault directly
D It identifies only the climate
Answer: A. It is an effective index fossil for correlation. Short time range, abundance, distinctiveness, and broad distribution make a fossil useful for correlation.
Two outcrops share a rare fossil assemblage but have different rock types. What can be inferred?
A They must be the same formation by definition
B They may be approximately time-correlative despite lithologic differences
C They formed in the same environment
D They must have identical thickness
Answer: B. They may be approximately time-correlative despite lithologic differences. Fossil correlation can link strata of similar age even where their lithologies differ.
A sandstone formation changes laterally into shale but remains part of the same time interval. What does this illustrate?
A A violation of superposition
B A reverse fault
C Lateral facies change and why lithologic boundaries may not be time boundaries
D A radiometric half-life
Answer: C. Lateral facies change and why lithologic boundaries may not be time boundaries. Depositional environments and rock type can change laterally, so lithostratigraphic contacts may be diachronous.
A dated volcanic ash lies below a fossil-bearing bed and above an older sandstone. What is the main value of the ash date?
A It proves the sandstone and fossils are the same age
B It determines the water depth exactly
C It eliminates relative dating
D It brackets the ages of adjacent sedimentary units
Answer: D. It brackets the ages of adjacent sedimentary units. A dated ash layer provides a numerical time marker that helps constrain the ages of nearby sedimentary beds.
An intrusion has an age of 90 million years and cuts a formation. What can be said about that formation?
A It is older than 90 million years
B It is younger than 90 million years
C It formed exactly 90 million years ago
D Its age cannot be bounded
Answer: A. It is older than 90 million years. A cross-cutting intrusion must be younger than the rocks it cuts, so the formation predates the 90-million-year intrusion.
A fossil-bearing layer is bracketed by a 120-million-year-old ash below and a 110-million-year-old ash above. What age range is supported?
A Older than 120 million years
B Between about 120 and 110 million years old
C Younger than 110 million years
D Exactly 115 million years
Answer: B. Between about 120 and 110 million years old. The bed was deposited after the lower ash and before the upper ash, so it falls within that interval.
A parent isotope has passed through two half-lives in a closed sample. What fraction of the original parent remains?
A One-half
B Three-quarters
C One-quarter
D One-eighth
Answer: C. One-quarter. After two half-lives, the parent fraction is one-half times one-half, or one-quarter.
After three half-lives, what fraction of the original parent isotope remains?
A One-quarter
B One-half
C Seven-eighths
D One-eighth
Answer: D. One-eighth. Each half-life halves the remaining parent, leaving one-eighth after three half-lives.
Why must a dated mineral system be interpreted carefully?
A The system should remain sufficiently closed to parent and daughter isotopes
B Every mineral has the same half-life
C Fossils stop radioactive decay
D All minerals begin with zero parent isotope
Answer: A. The system should remain sufficiently closed to parent and daughter isotopes. Radiometric ages rely on assumptions about isotope behavior, including whether parent or daughter products were added or lost.
A basal conglomerate contains pebbles of an older formation. What is the age relationship?
A The pebbles are younger than the matrix
B The pebbles are older than the conglomerate matrix
C The pebbles and matrix must be identical in age
D The conglomerate is older than every rock nearby
Answer: B. The pebbles are older than the conglomerate matrix. Included clasts existed before they were eroded and deposited in the younger conglomerate.
A fault cuts a formation but is sealed by an undeformed younger layer. What can be inferred?
A The faulting predates both layers
B The faulting postdates the sealing layer
C The faulting postdates the formation and predates the sealing layer
D The layers are the same age
Answer: C. The faulting postdates the formation and predates the sealing layer. The fault cuts the older formation but not the younger seal, bracketing faulting between them.
A fossil assemblage changes upward through a sequence and matches the same succession in a distant basin. What principle supports correlation?
A Original horizontality
B Uniformitarianism only
C Magnetic declination
D Fossil succession
Answer: D. Fossil succession. Recognizable changes in fossil assemblages through time allow biostratigraphic correlation between basins.
A marker ash can be traced across multiple outcrops and has a distinctive mineral content. Why is it useful?
A It provides a recognizable horizon for correlation
B It proves all overlying rocks are igneous
C It marks a fault’s slip direction
D It measures sediment porosity
Answer: A. It provides a recognizable horizon for correlation. A distinctive ash layer can be traced and used as a correlation horizon, especially if it can be dated.
A formation’s lower contact is gradational and its upper contact is erosional. What does that say about deposition?
A Both contacts must be faults
B The lower transition may be continuous, while the upper contact records a break
C The formation formed in one instant
D The upper contact proves the lower bed is younger
Answer: B. The lower transition may be continuous, while the upper contact records a break. A gradational lower contact can reflect changing deposition, while an erosional upper contact can mark missing time.
A stratigraphic section omits 20 million years at an unconformity. Does the preserved rock thickness represent that missing interval?
A Yes; every unconformity is a thick rock layer
B Only if the beds are tilted
C No; the gap is missing time, not a preserved bed
D It is always represented by sediment above it
Answer: C. No; the gap is missing time, not a preserved bed. An unconformity marks time not preserved by rock at that boundary; missing time is not itself a bed.
Two formations are separated geographically and cannot be seen in direct contact. What evidence can help correlate them?
A Only their present-day elevation
B Only the distance between outcrops
C Their names alone
D Fossils, rock properties, marker beds, and numerical ages
Answer: D. Fossils, rock properties, marker beds, and numerical ages. Correlation may use fossils, lithology, geophysical signatures, marker beds, and numerical-age constraints.
A time surface crosses from sandstone into shale without a time gap. Which unit type best follows the time surface?
A Chronostratigraphic unit
B Lithostratigraphic unit only
C A single mineral unit
D A fault-bounded block
Answer: A. Chronostratigraphic unit. A chronostratigraphic unit is defined by the time interval represented, even if lithology changes laterally.
A mapped formation is defined by sandstone composition and bedding, but its deposition took longer in one area than another. What caution applies?
A The formation must be a single instant in time
B The formation boundary may be diachronous
C The unit cannot be mapped
D All beds must be the same age
Answer: B. The formation boundary may be diachronous. Lithostratigraphic units follow rock characteristics and may cross time surfaces or be diachronous.
Which relative-age sequence follows a folded bed that is then cut by a dike and later eroded beneath an unconformity?
A Dike intrusion, deposition, erosion, folding, younger deposition
B Erosion, dike intrusion, younger deposition, deposition, folding
C Deposition, folding, dike intrusion, erosion, younger deposition
D All events happened at once
Answer: C. Deposition, folding, dike intrusion, erosion, younger deposition. The bed must first be deposited, then folded; the dike cuts it, erosion truncates the structures, and younger strata later cover the surface.