Difficulty: Easy & Basic
What does a radiator fan shroud help accomplish?
A Store coolant pressure
B Meter fuel delivery
C Direct airflow through core
D Open engine valves
Answer: C. Direct airflow through core. A shroud guides fan-induced air through the radiator core instead of around it.
How does a viscous fan clutch respond to temperature?
A Varies fan engagement
B Changes coolant chemistry
C Controls fuel pressure
D Alters piston stroke
Answer: A. Varies fan engagement. A thermal fan clutch increases fan drive as air or coolant temperature rises.
Which electrical device switches a high-current cooling fan?
A Fuel injector
B Fan relay
C Oil filter
D Thermostat housing
Answer: B. Fan relay. A relay lets a low-current control signal switch the fan’s larger current.
What may command an electric radiator fan?
A Thermal control signal
B Wheel alignment
C Fuel octane
D Clutch pedal travel
Answer: A. Thermal control signal. The control unit or thermal switch commands fan operation based on temperature and conditions.
Why pressure-test a cooling circuit?
A Find leaks and verify sealing
B Measure engine displacement
C Set ignition timing
D Check tire balance
Answer: A. Find leaks and verify sealing. A pressure test can reveal leaks and whether the system holds pressure.
Which test can detect combustion gas in coolant?
A Compression spring test
B Fuel trim test
C Wheel runout test
D Block test
Answer: D. Block test. A chemical block test can indicate combustion gases entering the cooling system.
What does vacuum filling help remove?
A Fuel contaminants
B Oil foam
C Trapped air pockets
D Exhaust soot
Answer: C. Trapped air pockets. Vacuum filling reduces trapped air while drawing coolant into the circuit.
After draining and refilling, why bleed specified air points?
A Raise fuel pressure
B Restore full coolant circulation
C Set spark-plug gap
D Balance crankshaft
Answer: B. Restore full coolant circulation. Air pockets can obstruct circulation and cause local overheating.
How can an externally blocked radiator core be restored?
A Increase engine compression
B Clean airflow passages
C Change tire size
D Raise fuel octane
Answer: B. Clean airflow passages. Removing dirt and debris restores airflow across the core.
What may internal scale deposits do to a radiator?
A Increase fan speed
B Raise battery capacity
C Lower fuel volatility
D Restrict coolant heat transfer
Answer: D. Restrict coolant heat transfer. Deposits can obstruct passages and insulate heat-transfer surfaces.
Which instrument can estimate coolant freeze protection?
A Tachometer
B Refractometer
C Torque wrench
D Manometer
Answer: B. Refractometer. A refractometer estimates concentration and freeze protection from refractive index.
Why should coolant color alone not determine compatibility?
A Color sets boiling point
B Color coding varies by product
C Color measures pressure
D Color fixes engine speed
Answer: B. Color coding varies by product. Coolant colors are not a universal specification for chemical compatibility.
Mixing incompatible coolant chemistries can cause what?
A Higher wheel torque
B Longer piston stroke
C Instant fuel vaporization
D Deposits or reduced protection
Answer: D. Deposits or reduced protection. Incompatible additives may react or reduce corrosion protection.
Why avoid an excessively concentrated glycol mixture?
A It always prevents corrosion
B It raises air density
C It eliminates coolant flow
D Heat transfer can worsen
Answer: D. Heat transfer can worsen. Very high glycol concentration can reduce heat capacity and heat-transfer performance.
What may coolant leaking from a pump weep hole indicate?
A Pump seal failure
B Fuel injector blockage
C Thermostat opening normally
D Radiator fan failure
Answer: A. Pump seal failure. A weep-hole leak can signal failure of the pump shaft seal.
A rough water-pump bearing may produce which clue?
A Low fuel octane
B Grinding or rumbling
C High tire pressure
D Silent valve timing
Answer: B. Grinding or rumbling. Bearing wear can cause audible grinding or rumbling and shaft play.
A slipping pump belt can cause what?
A Higher rail pressure
B More radiator capacity
C Reduced coolant circulation
D Lower coolant temperature
Answer: C. Reduced coolant circulation. A slipping drive belt can reduce water-pump speed and coolant flow.
A cabin heater stays cool while engine temperature rises. What may be restricted?
A Fuel return line
B Brake vacuum hose
C Heater-core coolant flow
D Air-filter inlet
Answer: C. Heater-core coolant flow. A blocked heater core or air pocket can reduce hot-coolant flow through it.
What does an engine oil cooler primarily cool?
A Intake charge
B Fuel vapor
C Lubricating oil
D Brake lining
Answer: C. Lubricating oil. An oil cooler removes heat from lubricating oil, often exchanging with air or coolant.
What does a charge-air cooler cool?
A Radiator coolant only
B Fuel in tank
C Exhaust after silencer
D Compressed intake air
Answer: D. Compressed intake air. An intercooler or charge-air cooler lowers temperature of compressed intake air.
How does thermosiphon cooling circulate fluid?
A Natural density differences
B Electric fan pressure
C High-pressure fuel pump
D Crankshaft rotation only
Answer: A. Natural density differences. Warmer, less-dense coolant rises while cooler fluid descends, creating natural circulation.
What does the vacuum valve in a radiator cap permit?
A Coolant return during cooling
B Fuel entry during refill
C Oil pressure release
D Air intake into cylinder
Answer: A. Coolant return during cooling. The vacuum valve allows coolant to return from the recovery reservoir as the system cools.
Why does a recovery reservoir support a sealed system?
A Raises engine compression
B Captures and returns coolant
C Filters fuel vapors
D Controls ignition timing
Answer: B. Captures and returns coolant. The recovery bottle accepts expansion and supplies coolant back during cool-down.
What should guide the coolant service interval?
A Coolant color only
B Tire replacement date
C Vehicle maker specification
D Engine speed alone
Answer: C. Vehicle maker specification. Coolant chemistry and service life vary, so follow the vehicle maker’s specification.
Why use a bypass passage when the thermostat is closed?
A Increase fuel pressure
B Open exhaust valve
C Raise radiator pressure
D Maintain internal circulation
Answer: D. Maintain internal circulation. A bypass lets coolant circulate through the engine while radiator flow is restricted during warm-up.