An automobile powertrain delivers what to the road wheels?
A Cooling water
B Exhaust pressure
C Battery chemistry
D Propulsive torque
Answer: D. Propulsive torque. The powertrain transmits engine or motor output to the driven wheels.
The chassis supports vehicle systems and what?
A Fuel chemistry
B Structural loads
C Road markings
D Tire pressure only
Answer: B. Structural loads. The chassis structure supports the body, powertrain, suspension and loads.
A monocoque body carries load through what?
A Separate ladder frame only
B Propeller shaft
C Integrated body shell
D Axle housing
Answer: C. Integrated body shell. A monocoque structure integrates body and load-bearing shell.
Sprung mass is supported by what vehicle component?
A Tire tread only
B Brake pads
C Wheel bearings only
D Suspension springs
Answer: D. Suspension springs. Sprung mass includes vehicle mass supported by the suspension.
Unsprung mass includes wheels and what?
A Non-suspended components
B Passenger cabin
C Engine block always
D Roof structure
Answer: A. Non-suspended components. Unsprung mass includes wheels, tires and components that move with them.
Wheelbase is distance between what?
A Front and rear axles
B Left and right wheels
C Bumper and axle
D Ground and chassis
Answer: A. Front and rear axles. Wheelbase is longitudinal distance between front and rear axle centers.
Track width is measured between what?
A Front and rear axles
B Left and right wheel centers
C Bumper edges
D Seat rows
Answer: B. Left and right wheel centers. Track is the lateral distance between wheel centers on an axle.
Ground clearance is the minimum gap between chassis and what?
A Roof and ground
B Engine and cabin
C Road surface
D Wheel and hub
Answer: C. Road surface. Ground clearance is the lowest vehicle point above the road, excluding tires.
Torque is a measure of what turning effect?
A Rotational moment
B Linear speed
C Heat flow
D Electrical resistance
Answer: A. Rotational moment. Torque is the moment of a force about an axis.
Mechanical power equals torque times what?
A Angular speed
B Wheelbase
C Gear count
D Tire radius squared
Answer: A. Angular speed. Rotational power is torque multiplied by angular velocity.
The drivetrain carries power from source to what?
A Radiator fan only
B Exhaust pipe
C Driven wheels
D Steering column
Answer: C. Driven wheels. Drivetrain components transmit power to the wheels.
An internal-combustion engine converts fuel energy into what?
A Mechanical work
B Road friction
C Battery charge only
D Suspension travel
Answer: A. Mechanical work. Combustion pressure produces useful mechanical output at the crankshaft.
A spark-ignition engine uses what to initiate combustion?
A Glow plug only
B Spark plug
C Compression alone
D Hydraulic valve
Answer: B. Spark plug. An SI engine ignites the air-fuel charge with an electrical spark.
A compression-ignition engine ignites fuel using what?
A Spark discharge
B External flame
C Battery heat
D Hot compressed air
Answer: D. Hot compressed air. Compression raises air temperature before fuel injection and autoignition.
A clutch connects or disconnects engine from what?
A Radiator
B Steering gear
C Transmission input
D Suspension damper
Answer: C. Transmission input. The clutch engages or interrupts torque flow between engine and transmission.
A transmission changes speed and what at the output?
A Torque
B Vehicle mass
C Wheelbase
D Fuel octane
Answer: A. Torque. Gear ratios trade output speed for torque.
A differential allows driven wheels to rotate at what?
A Same speed always
B Zero speed
C Engine speed only
D Different speeds
Answer: D. Different speeds. The differential accommodates differing wheel speeds during a turn.
The final drive provides additional reduction and what?
A Cooling capacity
B Steering assist
C Brake pressure
D Torque multiplication
Answer: D. Torque multiplication. Final-drive gearing reduces speed and increases torque at the wheels.
An axle transmits torque and supports what?
A Fuel injectors
B Exhaust gases
C Wheel loads
D Valve timing
Answer: C. Wheel loads. Axles transmit torque and carry wheel and vehicle loads.
A propeller shaft commonly connects transmission to what?
A Radiator inlet
B Final drive
C Steering rack
D Brake pedal
Answer: B. Final drive. A propeller shaft transfers torque to a remote differential.
Front-engine rear-wheel drive sends engine torque to which wheels?
A Rear wheels
B Front wheels only
C All wheels always
D Steering wheels only
Answer: A. Rear wheels. In a conventional FR layout, the rear axle is driven.
Front-wheel drive places propulsion at which wheels?
A Rear wheels only
B Front wheels
C Trailer wheels
D All wheels always
Answer: B. Front wheels. FWD uses the front wheels for both steering and traction.
All-wheel drive can distribute torque to what?
A One front wheel only
B Both axles
C Steering rack
D Engine accessories
Answer: B. Both axles. AWD systems can send torque to front and rear axles.
Payload is vehicle load excluding what?
A Fuel mass
B Passengers
C Vehicle curb mass
D Cargo
Answer: C. Vehicle curb mass. Payload is the allowable carried load, separate from the vehicle’s own curb mass.
Curb mass usually includes operating fluids but excludes what?
A Engine
B Wheels
C Body
D Payload
Answer: D. Payload. Curb mass is the ready-to-operate vehicle without occupants or cargo.