Across a sudden pipe expansion, the Borda–Carnot head loss depends on which quantity?
A (V₁+V₂)/(2g)
B V₁V₂/g
C (V₁²+V₂²)/g
D (V₁−V₂)²/(2g)
Answer: D. (V₁−V₂)²/(2g). For a sudden expansion, h_L=(V₁−V₂)²/(2g), with velocities in the small and large sections.
Steady incompressible pipes connected in series carry what?
A The same mean speed
B The same diameter
C The same pressure
D The same flow rate
Answer: D. The same flow rate. Mass conservation requires the same volume flow rate through every series element.
Connected parallel branches share which energy quantity between their junctions?
A Mean velocity
B Pipe diameter
C Head loss
D Friction factor
Answer: C. Head loss. Each parallel branch connects the same upstream and downstream nodes, so its head loss is equal.
Momentum thickness in a boundary layer quantifies deficit of which flux?
A Streamwise momentum flux
B Mass flow rate only
C Heat transfer rate
D Pressure force only
Answer: A. Streamwise momentum flux. Momentum thickness measures the integrated streamwise momentum deficit caused by the boundary layer.
For inviscid flow past a cylinder with no circulation, surface stagnation points occur where?
A Front and rear
B Top and bottom
C Quarter points
D Rear point only
Answer: A. Front and rear. Symmetric uniform potential flow around a cylinder has zero surface speed at its upstream and downstream stagnation points.
In steady incompressible, irrotational, inviscid flow, Bernoulli’s constant applies how?
A Only at walls
B Across streamlines
C Only at stagnation points
D Only in turbulent cores
Answer: B. Across streamlines. For steady inviscid flow, Bernoulli is constant along streamlines; irrotational flow permits the same constant across streamlines.
Vorticity in a three-dimensional flow equals the curl of which field?
A Pressure
B Velocity
C Density
D Temperature
Answer: B. Velocity. Vorticity is defined as ∇×V, the curl of the velocity field.
Circulation around a closed curve integrates which velocity component?
A Normal pressure
B Radial acceleration
C Tangential velocity
D Fluid density
Answer: C. Tangential velocity. Circulation is ∮V·dl, integrating the velocity component tangent to the path.
Euler’s equation models fluid momentum while neglecting which effect?
A Gravity
B Pressure forces
C Viscous stress
D Inertia
Answer: C. Viscous stress. Euler’s equation is the inviscid momentum equation; it omits viscous stresses.
The Navier–Stokes momentum equation includes which Newtonian-fluid property?
A Viscosity
B Surface tension only
C Specific gravity
D Bulk modulus only
Answer: A. Viscosity. Navier–Stokes includes viscous stress effects, commonly represented through dynamic viscosity.
At equal elevation in ideal incompressible flow, stagnation pressure equals static pressure plus what?
A Vapour pressure
B Gauge pressure
C Dynamic pressure
D Hydrostatic head
Answer: C. Dynamic pressure. For ideal incompressible flow, p₀=p+½ρV² at the same elevation.
Across a normal shock, supersonic gas flow becomes what downstream?
A Subsonic flow
B Supersonic flow
C Zero flow
D Exactly sonic flow
Answer: A. Subsonic flow. Across a normal shock, supersonic upstream flow becomes subsonic downstream, with pressure and temperature rising.
For supersonic flow, Mach angle μ satisfies which relation?
A cos μ = M
B sin μ = 1/M
C tan μ = 1/M²
D μ = M
Answer: B. sin μ = 1/M. Mach angle is defined by sin μ=1/M for M>1.
In a converging-diverging nozzle, which section accelerates supersonic flow?
A Diverging section
B Converging section
C Constant-area inlet
D Plenum chamber
Answer: A. Diverging section. Once flow is supersonic after the throat, increasing area accelerates it in a diverging section.
Sufficiently low back pressure causes a nozzle to reach which mass-flow condition?
A Choked flow
B Hydrostatic flow
C Creeping flow
D Potential flow
Answer: A. Choked flow. At the critical pressure ratio, throat flow reaches Mach 1 and mass flow is choked.
Hydraulic jump converts open-channel flow from which state to which?
A Subcritical to supercritical
B Laminar to turbulent
C Uniform to hydrostatic
D Supercritical to subcritical
Answer: D. Supercritical to subcritical. A hydraulic jump converts supercritical shallow flow into subcritical deeper flow with substantial energy dissipation.
Critical open-channel flow has what Froude number?
A Zero
B One-half
C Two
D One
Answer: D. One. Critical flow is defined by Froude number equal to one.
During uniform open-channel flow, the energy grade line is parallel to what?
A Free surface only
B Side wall
C Channel bed
D Flow vector
Answer: C. Channel bed. In uniform flow, depth and velocity remain constant, so the energy slope equals the bed slope.
To avoid pump cavitation, available NPSH should exceed what?
A Vapour pressure head
B Required NPSH
C Delivery head
D Static lift only
Answer: B. Required NPSH. A practical cavitation margin requires NPSH available to exceed the pump’s required NPSH.
Pump operating point lies where which two curves intersect?
A Velocity and pressure
B Pump and system
C Reynolds and Froude
D Head and diameter
Answer: B. Pump and system. The operating point is where the pump head-flow curve meets the system head-flow curve.
Free-surface gravity-flow model tests commonly match which dimensionless number?
A Mach number
B Reynolds stress
C Froude number
D Prandtl number
Answer: C. Froude number. Froude similarity is central when gravity and free-surface effects dominate.
Viscous internal-flow model similarity commonly matches which number?
A Mach angle
B Euler length
C Weber pressure
D Reynolds number
Answer: D. Reynolds number. Matching Reynolds number preserves the ratio of inertial to viscous effects between model and prototype.
In simple Couette flow between plates, shear stress depends on viscosity and what?
A Pressure head only
B Velocity gradient
C Pipe diameter
D Fluid density only
Answer: B. Velocity gradient. For Newtonian Couette flow, τ=μ du/dy, so shear stress follows the velocity gradient.
Fully developed laminar flow in a circular pipe has centreline speed how related to mean speed?
A Twice the mean
B Equal to mean
C Half the mean
D Three times the mean
Answer: A. Twice the mean. The parabolic profile gives centreline speed twice the cross-sectional mean.
Stopping a freely exposed water jet of area A and speed V axially produces force equal to what?
A ρAV
B ρA²V
C ρV²/A
D ρAV²
Answer: D. ρAV². Stopping the axial jet velocity changes momentum at rate ρAV², equal to the force magnitude.