During fractional crystallization, early-formed crystals are removed from a magma. The remaining melt commonly becomes:
ASame as early crystals
BMore evolved, silica-rich melt
C A solid metamorphic rock immediately
D A sedimentary slurry
Answer: B. More evolved and relatively richer in silica. Removing early crystals changes the residual melt; it commonly becomes more evolved and relatively silica-rich.
A mafic magma compared with a felsic magma generally has:
ALower silica; Fe-Mg rich
B No dissolved gases
CHigher silica; less Fe-Mg
DSame chemistry, different colour
Answer: A. Lower silica and relatively more iron and magnesium. Mafic magmas are relatively low in silica and richer in iron and magnesium than felsic magmas.
Why is high-silica rhyolitic magma often more viscous than basaltic magma?
ASilica-rich melt resists flow
B Basalt is always colder underground
CColour controls viscosity
D Rhyolite contains no oxygen
Answer: A. Silica-rich melt structures resist flow more strongly. Higher silica content generally increases melt polymerization and viscosity.
Peridotite is classified as ultramafic mainly because it is rich in:
A Feldspar and volcanic glass
B Calcite and halite
COlivine, pyroxene; low silica
D Quartz and muscovite
Answer: C. Olivine and pyroxene and relatively low in silica. Peridotite is an ultramafic mantle rock dominated by olivine and pyroxene.
If two magmas have similar composition but one cools much more slowly, the slower-cooled rock is more likely to have:
A More rounded clasts
B Larger crystals
C More cleavage planes
D More fossils
Answer: B. Larger crystals. Slower cooling allows crystals more time to grow, producing a coarser texture.
A porphyritic texture can preserve evidence of:
ASlow then fast cooling
BOne metamorphic stage
C Repeated mineral scratching
DSediment cemented twice
Answer: A. An early slow-cooling stage followed by faster cooling. Phenocrysts can grow during slow cooling before the remaining melt cools more rapidly.
Why are pegmatites commonly associated with the late stages of granitic magma crystallization?
ASurface sediment
BVolatiles aid crystal growth
C They contain no magma-derived material
DWeathering alone
Answer: B. Residual melts can be enriched in water and other volatiles that promote crystal growth. Volatile-rich residual melts can remain mobile and promote exceptionally large crystals late in crystallization.
A coarse-grained mafic pluton and a fine-grained mafic lava may be compositionally similar. Which pair is most likely?
A Schist and slate
B Granite and rhyolite
C Gabbro and basalt
D Diorite and limestone
Answer: C. Gabbro and basalt. Gabbro is intrusive and coarse-grained; basalt is extrusive and fine-grained, and both are commonly mafic.
In Bowen’s discontinuous series, which sequence correctly progresses from higher to lower crystallization temperature?
AOlivine, pyroxene, amphibole, biotite
BBiotite, olivine, amphibole, pyroxene
CFeldspar, diamond, calcite, quartz
DQuartz, olivine, biotite, pyroxene
Answer: A. Olivine → pyroxene → amphibole → biotite. The discontinuous ferromagnesian sequence progresses from olivine to pyroxene, amphibole, and biotite as temperature falls.
A calcium-rich plagioclase crystal forming early in a cooling magma may be followed by progressively more:
AIron-rich olivine only
B Sodium-rich plagioclase at lower temperatures
C Pure quartz replacing all feldspar
D Halite at the same temperature
Answer: B. Sodium-rich plagioclase at lower temperatures. The continuous plagioclase series shifts from calcium-rich toward sodium-rich compositions as magma cools.
Contact metamorphism is most likely to produce a strong thermal effect with:
ALava rapidly cools
BPressure without heat
CContinental low temperature
DHigh heat near intrusion
Answer: D. High temperature near an intrusion and comparatively limited regional pressure. Contact metamorphism is driven chiefly by heat from an intrusion and commonly affects a localized aureole.
Regional metamorphism during mountain building commonly combines heat with:
A Only chemical weathering
BBurial and directed pressure
C Rapid volcanic quenching
D Surface evaporation and salt precipitation
Answer: B. Burial and directed tectonic pressure over a broad area. Regional metamorphism affects large areas during tectonic burial, heating, and deformation.
Blueschist facies is associated most characteristically with:
AHigh-pressure, low-temperature subduction
BLow-pressure, high-temperature intrusion
C Surface weathering of basalt
D Rapid crystallization of rhyolite
Answer: A. High pressure and relatively low temperature in subduction settings. Blueschist minerals such as glaucophane form under high-pressure, relatively low-temperature conditions typical of some subduction zones.
Eclogite is recognized by which characteristic mineral assemblage?
A Calcite with gypsum
B Olivine with volcanic glass only
C Quartz with halite
D Garnet with omphacitic pyroxene
Answer: D. Garnet with omphacitic pyroxene. Eclogite is a high-pressure metamorphic rock commonly characterized by garnet and omphacitic pyroxene.
Why should index minerals be interpreted with both pressure and temperature context?
AColour gives exact depth
BForms at every pressure
CCondition- and composition-dependent stability
DOnly in sedimentary rocks
Answer: C. Mineral stability depends on conditions and bulk composition, so one mineral is not a universal thermometer. Index minerals indicate metamorphic conditions, but their stability also depends on composition and geological context.
Foliation in a deformed metamorphic rock commonly develops roughly:
AFoliation perpendicular to compression
BRight angles to cleavage
CAfter complete melting
DParallel to every fracture
Answer: A. Perpendicular to the greatest compressive stress as platy minerals align. Directed compression tends to align platy or elongate minerals, commonly producing foliation perpendicular to maximum compression.
A marble remains non-foliated after metamorphism mainly because calcite grains:
A Contain no crystal structure
B Cannot recrystallize
CWeak aligned platy fabric
D Are always liquid during metamorphism
Answer: C. Do not commonly form a strong aligned platy fabric under ordinary conditions. Calcite grains typically recrystallize without forming the aligned platy fabric seen in many foliated rocks.
A mixed rock containing metamorphic bands and igneous-looking segregations may be a migmatite, suggesting:
A Only low-temperature cementation
BSurface lava, no metamorphism
C Partial melting during high-grade metamorphism
D Mechanical sorting of pebbles
Answer: C. Partial melting during high-grade metamorphism. Migmatites record high-grade conditions where some portions of a metamorphic rock partially melted.
Metasomatism differs from simple recrystallization because it involves:
AAlways melts and erupts
BFluid-driven chemical mass transfer
C Only grain-size change by compaction
DCrystal growth without fluids
Answer: B. Chemical mass transfer by fluids that changes bulk composition. Metasomatism involves chemical exchange with fluids that can add or remove components from a rock.
Diagenesis is distinguished from metamorphism mainly because diagenesis generally occurs:
ALow-temperature sediment lithification
BMantle temperatures above 1000°C
C Only in intrusive igneous bodies
D After complete melting
Answer: A. At lower temperatures and pressures during sediment lithification. Diagenesis includes low-temperature changes such as compaction and cementation after deposition.
A metamorphic rock develops alternating mineral-rich bands during deformation. Which process best explains the banding?
A Evaporation of a shallow lake
B Gas bubbles trapped in lava
CMineral segregation and recrystallization
DRiver-sorted rounded clasts
Answer: C. Mineral segregation and recrystallization under metamorphic conditions. Gneissic banding can form as minerals segregate and recrystallize during high-grade metamorphism.
A sedimentary bed contains well-rounded, well-sorted grains. Which inference is most defensible?
AVolcanic ash deposit
BPluton crystals
C The rock underwent high-grade foliation
DWater- or wind-sorted transport
Answer: D. The grains experienced transport and hydraulic or wind sorting. Rounding and sorting generally record transport and depositional processes, though they do not uniquely determine one environment.
Which trio correctly represents the main origin-based categories of rocks?
A Clastic, foliated, vesicular
B Quartz, feldspar, mica
C Felsic, mafic, ultramafic
D Igneous, sedimentary, metamorphic
Answer: D. Igneous, sedimentary, metamorphic. Rocks are conventionally grouped by origin as igneous, sedimentary, or metamorphic.
A sedimentary rock made from shell fragments and carbonate mud is best classified as:
A Intrusive ultramafic rock
B Foliated metamorphic rock
C Volcanic glass
D Biochemical or bioclastic carbonate rock
Answer: D. Biochemical or bioclastic carbonate rock. Carbonate rocks made from biological shell material are bioclastic or biochemical sedimentary rocks.
Why is a single rock’s mineral assemblage not always enough to identify its full geologic history?
ATexture unrelated to origin
B Only colour reveals geologic history
C Minerals never preserve information
DTexture and field context matter
Answer: D. Different processes can produce similar assemblages, so texture and field context also matter. Interpretation combines mineralogy, texture, structures, and field relationships because no single feature is always unique.