A renewable energy source is naturally what?
A Consumed once only
B Replenished over time
C Made from coal only
D Stored in batteries only
Answer: B. Replenished over time. Renewable sources are replenished naturally on timescales relevant to human use.
Photovoltaic cells convert sunlight directly into what?
A Electrical energy
B Mechanical torque
C Combustion heat
D Hydraulic pressure
Answer: A. Electrical energy. PV cells convert incident light into electrical power.
The photovoltaic effect occurs in which material?
A Copper winding only
B Semiconductor junction
C Steel gear
D Liquid electrolyte only
Answer: B. Semiconductor junction. Light-generated carriers in a semiconductor junction produce electrical current.
A solar cell commonly contains what junction?
A p-n junction
B Gear mesh
C Hydraulic seal
D Thermocouple junction only
Answer: A. p-n junction. A p-n junction separates and drives photo-generated charge carriers.
Solar irradiance is commonly measured in what units?
A Kilowatt-hours per day
B Joules per kilogram
C Metres per second
D Watts per square metre
Answer: D. Watts per square metre. Irradiance is instantaneous solar power per unit area.
Daily solar insolation is often stated in what units?
A W per square metre only
B Joules per kelvin
C kWh per square metre
D Amperes per hour
Answer: C. kWh per square metre. Insolation is solar energy received per area over a time period.
PV cells connected in series mainly increase what?
A Current only
B Panel area
C Voltage
D Frequency
Answer: C. Voltage. Series-connected cells add their voltages.
PV strings connected in parallel mainly increase what?
A Voltage only
B Cell temperature
C Current
D Frequency
Answer: C. Current. Parallel strings add their current capacity.
A PV inverter converts DC electricity into what?
A AC electricity
B Hydrogen
C Thermal energy
D Mechanical energy
Answer: A. AC electricity. Grid and AC loads generally require an inverter to convert PV DC output.
Maximum power point tracking adjusts operation to maximize what?
A Cell temperature
B Panel weight
C Grid frequency only
D PV output power
Answer: D. PV output power. MPPT varies electrical operating point to extract maximum available PV power.
A solar charge controller regulates charging of what?
A Battery bank
B Wind turbine rotor
C Hydraulic reservoir
D Grid transformer only
Answer: A. Battery bank. A charge controller manages battery charging from solar modules.
A bypass diode helps a PV module during what condition?
A Night cooling
B High wind
C Battery discharge only
D Partial shading
Answer: D. Partial shading. Bypass diodes reduce hot spots and power loss from shaded cell groups.
PV conversion efficiency is electrical output divided by incident what?
A Battery capacity
B Solar power
C Panel mass
D Wind speed
Answer: B. Solar power. Module efficiency compares electrical power with solar power incident on module area.
Panel tilt angle affects captured solar what?
A Battery chemistry
B Inverter frequency
C Irradiation
D Cell count only
Answer: C. Irradiation. Tilt changes the angle of incidence and seasonal energy capture.
Panel azimuth specifies its horizontal what?
A Tilt angle
B Cell voltage
C Temperature rating
D Facing direction
Answer: D. Facing direction. Azimuth describes the compass direction a panel faces.
Monocrystalline PV cells are made from what crystal structure?
A Multiple metal films
B Liquid electrolyte
C Ceramic oxide only
D Single silicon crystal
Answer: D. Single silicon crystal. Monocrystalline cells use silicon wafers from a single crystal.
Thin-film PV deposits semiconductor material on what?
A Rotating shaft
B Wind blade
C Substrate
D Hydraulic piston
Answer: C. Substrate. Thin-film cells deposit a thin semiconductor layer onto a supporting substrate.
Standard test conditions specify irradiance and cell what?
A Temperature
B Wind direction
C Battery voltage
D Inverter speed
Answer: A. Temperature. PV STC includes reference irradiance and cell temperature for ratings.
PV output typically decreases as cell temperature what?
A Drops to zero
B Increases
C Remains irrelevant
D Equals ambient always
Answer: B. Increases. Most silicon PV modules have a negative power temperature coefficient.
A grid-tied PV system must prevent what during outage?
A Solar conversion
B Series connection
C Battery charging
D Islanding
Answer: D. Islanding. Anti-islanding protection disconnects the inverter when grid voltage is absent.
An off-grid PV system commonly includes what storage?
A Steam condenser
B Batteries
C Transmission tower
D Cooling tower
Answer: B. Batteries. Off-grid systems often use batteries to supply loads when sunlight is unavailable.
Net metering measures electricity imported and what?
A Stored as heat
B Exported to grid
C Used by inverter only
D Lost in cables only
Answer: B. Exported to grid. Bidirectional metering records energy taken from and supplied to the grid.
A solar thermal collector captures sunlight as what?
A Heat
B Electrical current directly
C Wind power
D Chemical fuel
Answer: A. Heat. Solar thermal collectors absorb radiation and transfer heat to a working fluid.
A solar thermal storage tank stores what?
A Wind momentum
B Grid frequency
C Heat
D Electric charge only
Answer: C. Heat. Thermal storage retains heat for later use.
A solar tracker changes panel orientation to follow what?
A Sun position
B Grid frequency
C Wind speed
D Battery charge
Answer: A. Sun position. Trackers adjust collector orientation to maintain favorable alignment with the sun.