Population Distribution MCQs (Set-3)

Difficulty: Medium

District A contains 720,000 people within 1,200 km². What is its arithmetic density?

A 60 persons per square kilometre
B 600 persons per square kilometre
C 864 persons per square kilometre
D 1,920 persons per square kilometre

District P and District Q each have 900,000 residents. P covers 1,500 km² and Q covers 3,000 km². Which comparison is correct?

A Q has twice P’s density
B Both have equal density
C P has half Q’s density
D P has twice Q’s density

A valley plain has dense settlement, while nearby high slopes are sparsely settled. Which explanation best fits the contrast?

A Relief changes accessibility and the land available for farming and construction
B Population density is unrelated to the physical landscape
C High slopes always have richer alluvial soils than plains
D Every person in the valley must have migrated from abroad

A desert district has low average density, but a town clusters around a dependable water source. What does this illustrate?

A Arid regions cannot contain any settlement
B A national census excludes towns in deserts
C Local resources can create a population concentration within a generally sparse region
D Density is always identical across a district

Which measure is most useful for estimating the pressure of the whole population on cultivated land?

A Arithmetic density
B Urbanisation rate
C Physiological density
D Decadal growth rate

Which formula describes agricultural density in the NCERT framework?

A Total population divided by the entire land area
B Total agricultural population divided by net cultivable area
C Urban population divided by built-up land
D Rural population divided by total population

A researcher needs a comparable nationwide population-per-area figure from Census 2011. Which value should be used?

A 325 persons per square kilometre
B 17 persons per square kilometre
C 11,297 persons per square kilometre
D 382 persons per square kilometre

A compact city territory has a moderate population count but very high density. What is the likeliest reason?

A Its population is concentrated within a small land area
B Its area is larger than a state
C Density is calculated from annual births alone
D Its residents are counted more than once in every census

Which map is suited to comparing state-level population-density classes?

A A choropleth map with a clear density legend
B A rainfall-only isohyet map
C A geological map without population data
D A route map showing rail lines only

A state has a very large population but also an extensive area. What must be calculated before calling it densely populated?

A Population divided by birth rate
B Area divided by rainfall
C Population divided by area
D Urban population divided by state count

Which state value matches the Census 2011 density figure of 1,102 persons per km²?

A Kerala
B Bihar
C Arunachal Pradesh
D Rajasthan

A table lists a state at 17 persons per km². Which state is indicated by the Census 2011 map?

A Bihar
B Uttar Pradesh
C Tamil Nadu
D Arunachal Pradesh

Which Census 2011 unit recorded a density of 11,297 persons per km²?

A Bihar
B West Bengal
C National Capital Territory of Delhi
D Arunachal Pradesh

Among Kerala and Tamil Nadu, which had the higher density in Census 2011?

A Kerala, at 859 persons per km²
B Tamil Nadu, at 859 persons per km²
C Kerala, at 555 persons per km²
D They both had 382 persons per km²

India’s average density rose from 325 in 2001 to 382 in 2011. What does this change represent?

A An increase of 57 million people
B A decrease of 57 persons per square kilometre
C A doubling of population density
D An increase of 57 persons per square kilometre

Why compare census counts collected at regular intervals?

A To replace area measurements with rainfall records
B To observe population change on a consistent time basis
C To calculate terrain height from settlement maps
D To avoid distinguishing urban and rural residents

Region R has 4 million people on 20,000 km². Region S has 3 million people on 10,000 km². Which is denser?

A Region S, at 300 persons per km²
B Region R, at 200 persons per km²
C Region R, at 300 persons per km²
D They have equal density

Which statement about comparing population totals is accurate?

A The most populous state must always be the densest
B Area can be ignored when comparing density
C The larger total population does not necessarily mean the higher density
D A smaller state cannot have a high density

A new industrial hub offers many jobs and is linked to nearby towns. Which distributional change is plausible?

A The surrounding land area will shrink automatically
B The region must become less accessible
C The census will stop counting rural households
D Population may concentrate near the employment and transport node

A city’s population grows through net in-migration while its boundary remains unchanged. What happens to its density, all else equal?

A It decreases
B It increases
C It stays the same
D It becomes a measure of rainfall

Why do many parts of the Thar have lower density than the Ganga plain?

A The desert has more alluvial soil and larger rivers
B Water scarcity and aridity contrast with the plain’s water and fertile soils
C The Ganga plain is uniformly mountainous
D The Thar has no towns while the plain has no villages

Which pair of sources would best help a student explain density patterns across India?

A A census density map and a relief map
B A language map and a postage stamp collection
C A railway timetable and a list of holidays
D An election map and an ocean temperature chart

A district census table shows rural and urban counts separately. What can the analyst compare directly?

A The exact population of each household without additional data
B Annual rainfall in rural versus urban areas
C How the population is divided between rural and urban areas
D The district’s average elevation

Two districts have equal populations. District M covers 800 km² and N covers 400 km². Which is denser?

A District M, with twice N’s density
B Both have the same density
C Neither can have a density value
D District N, with twice M’s density

A region’s total population is unchanged but its net cultivated area falls. What happens to its physiological density?

A It falls
B It is unchanged by cultivated area
C It rises
D It becomes equal to arithmetic density