Answer: B. Dissolved-salt concentration. Salinity expresses the dissolved-salt content of water; it is often reported as mass of salts per mass of seawater.
A commonly used approximate average salinity for open-ocean surface water is:
A About 3.5 kilograms per litre
B About 35 g/kg seawater
C About 350 grams per kilogram
D Exactly 0 grams per kilogram
Answer: B. About 35 g/kg seawater. A useful broad average is about 35 g/kg, though local salinity varies with evaporation, precipitation, runoff and ice processes.
When evaporation removes water from the ocean surface but leaves most salts behind, surface salinity generally:
A Changes into water temperature
B Increases
C Remains fixed at every location
D Falls to zero
Answer: B. Increases. Evaporation removes water molecules and concentrates dissolved salts in the remaining surface water.
Heavy rainfall over the sea surface generally tends to:
A Raise salinity by removing freshwater
B Increase dissolved rock instantly
C Lower near-surface salinity
D Stop nearby evaporation
Answer: C. Lower near-surface salinity. Rain adds freshwater to the ocean surface and can dilute the surface layer, especially where mixing is limited.
A large river entering a coastal sea usually creates what salinity pattern near its mouth?
A Fresher surface water mixing seawater
B Salinity never changes with flow
C Permanent hypersaline increase
D Pure salt above river water
Answer: A. Fresher surface water mixing seawater. River discharge supplies freshwater, producing a lower-salinity plume that mixes with surrounding seawater.
During sea-ice formation, what tends to happen to much of the salt originally dissolved in the freezing water?
A All salts enter ice crystals
B Salt becomes oxygen gas
C Salt disappears permanently
D Salt rejection raises seawater density
Answer: D. Salt rejection raises seawater density. Growing sea ice excludes most salt, leaving brinier water nearby. This local increase in salinity can raise water density.
When floating sea ice melts, the nearby surface water commonly becomes:
A Abyssal water
B Always more saline
C Fresher
D Completely salt-free
Answer: C. Fresher. Melting adds freshwater to the surface ocean, which can reduce local salinity unless offset by other processes.
For most near-surface seawater that is not close to its freezing point, what is the usual density effect of warming?
A Expansion lowers density
B Density is unrelated to temperature
C Warming increases density
D The water instantly becomes solid
Answer: A. Expansion lowers density. Warm water expands and is usually less dense than colder seawater of the same salinity.
If temperature is held constant, increasing seawater salinity generally makes the water:
A Less salty
B Less dense
C More compressible by exactly zero
D Denser
Answer: D. Denser. Dissolved salts add mass to a given volume of water, so salinity increases seawater density.
Why does seawater freeze at a lower temperature than freshwater?
A Dissolved salts lower freezing point
B Waves remove all heat
C Oceans never freeze
D Salt raises freezing above 0Β°C
Answer: A. Dissolved salts lower freezing point. Dissolved salts interfere with formation of the ice lattice, lowering the temperature at which seawater begins to freeze.
Near the surface, seawater with salinity around 35 g/kg begins to freeze at approximately:
A +5Β°C
B β1.9Β°C
C β35Β°C
D 0Β°C exactly
Answer: B. β1.9Β°C. Typical seawater freezes near β1.9Β°C at ordinary ocean pressure, though the value varies with salinity and pressure.
Which term describes a layer where temperature changes rapidly with depth?
A Halocline
B Pycnocline
C Thermocline
D Neritic zone
Answer: C. Thermocline. A thermocline is a vertical zone of relatively rapid temperature change, commonly separating warm surface water from colder deep water.
An ocean layer marked by a strong vertical change in density is called a:
A Pycnocline
B Thermocline
C Abyssal plain
D Halocline
Answer: A. Pycnocline. A pycnocline is a layer in which seawater density changes rapidly with depth, often because of temperature and salinity gradients.
Which oceanographic term refers to a zone with a sharp change in salinity with depth?
A Shelf break
B Halocline
C Thermocline
D Pycnocline
Answer: B. Halocline. A halocline is a layer where salinity varies rapidly with depth.
The near-surface mixed layer is commonly kept relatively uniform by:
A Pressure increasing at the seafloor
B Rising salt crystals
C Tides stopping vertical motion
D Wind stirring and wave-driven mixing
Answer: D. Wind stirring and wave-driven mixing. Wind and waves mix the upper ocean, often creating a surface layer with relatively uniform temperature and salinity.
In many tropical oceans, the permanent thermocline is generally:
A Located above the sea surface
B Absent; sunlight reaches bottom
C Persistent; higher-latitude layers vary
D A sea-ice layer
Answer: C. Persistent; higher-latitude layers vary. Strong year-round solar heating in the tropics commonly maintains a warm surface layer above a persistent thermocline.
About how much does hydrostatic pressure increase for each 10 m of seawater depth?
A Roughly one hundred atmospheres
B Depth does not raise pressure
C Roughly one pascal
D Roughly one additional atmosphere
Answer: D. Roughly one additional atmosphere. A useful approximation is about one atmosphere of additional pressure for every 10 m of seawater, on top of surface atmospheric pressure.
The photic zone is the ocean layer where:
A All water is frozen
B Enough light supports photosynthesis
C Pressure is always zero
D No organisms can survive
Answer: B. Enough light supports photosynthesis. The photic zone receives sufficient light for photosynthesis; its depth varies with water clarity and conditions.
Why does the amount of sunlight generally diminish with ocean depth?
A Gravity pulls light downward
B Seafloor reflects all light
C Salinity creates surface light
D Water absorbs and scatters light
Answer: D. Water absorbs and scatters light. Water absorbs and scatters light, so less solar energy is available deeper down; different wavelengths penetrate to different depths.
At similar pressure and salinity, colder seawater can hold more dissolved oxygen than warmer seawater. This difference mainly reflects:
A Salt converting oxygen to nitrogen
B Cold water creates oxygen
C Zero pressure in cold regions
D Colder water holds more oxygen
Answer: D. Colder water holds more oxygen. Gas solubility generally increases as water temperature decreases, allowing cold seawater to contain more dissolved oxygen at saturation.
A CTD instrument used by oceanographers records which three variables?
A Cloud, tide and direction
B Carbon, time and density only
C Conductivity, temperature and depth
D Current, turbidity and distance only
Answer: C. Conductivity, temperature and depth. CTD stands for conductivity, temperature and depth; conductivity is used to infer salinity when combined with other measurements.
Why can electrical conductivity help estimate seawater salinity?
A Dissolved ions carry current
B Salinity affects sound, not conductivity
C Conductivity measures only water depth
D Pure water conducts better
Answer: A. Dissolved ions carry current. The dissolved ions in seawater carry electrical current. Conductivity, together with temperature and pressure, is used to estimate salinity.
Water in an estuary is often described as brackish because it:
A Never mixes with river water
B Contains no dissolved ions
C Mixes fresh and seawater
D Always saltier than ocean
Answer: C. Mixes fresh and seawater. An estuary is a coastal mixing environment where river freshwater and marine saltwater combine, producing salinity between the two end members.
A semi-enclosed sea with strong evaporation and limited freshwater input may develop:
A Saltier than nearby open ocean
B Freshwater cap all year
C No density variation
D Zero salinity at the surface
Answer: A. Saltier than nearby open ocean. Where evaporation greatly exceeds freshwater input and exchange is restricted, salts can become concentrated and salinity can rise.
How does the ocean’s high heat capacity influence nearby coastal climates?
A Ocean moderates temperature swings
B It creates daily extremes
C Removes atmospheric water vapour
D Stops all seasonal variation
Answer: A. Ocean moderates temperature swings. Seawater can absorb or release considerable heat with relatively small temperature changes, often moderating temperatures near coasts.