Seismic energy begins at a point beneath the ground called the:
A Hypocentre or focus
B Seismic gap
C Fault scarp
D Epicentre
Answer: A. Hypocentre or focus. The hypocentre, also called the focus, is the underground point where an earthquake rupture begins.
The point on Earth’s surface directly above an earthquake focus is its:
A Intensity centre
B Fault plane
C Aftershock
D Epicentre
Answer: D. Epicentre. The epicentre is the surface location vertically above the earthquake focus.
Which measure gives a single value for the size of an earthquake?
A Magnitude
B Intensity
C Vulnerability
D Exposure
Answer: A. Magnitude. Magnitude describes earthquake size; a given earthquake has one reported magnitude value.
Which measure can differ from one town to another during the same earthquake?
A Earthquake intensity
B Moment magnitude
C Focus depth only
D Plate age
Answer: A. Earthquake intensity. Intensity measures shaking and effects at a location, so values vary across the affected area.
The U.S. Geological Survey currently reports earthquake magnitude primarily using:
A Saffir–Simpson scale
B Beaufort scale
C Moment magnitude
D Modified Mercalli Intensity
Answer: C. Moment magnitude. USGS reports earthquake magnitudes using the moment magnitude scale, though other magnitude measures are used in research.
Shaking causes loose, water-saturated sediment to lose strength and behave temporarily like a fluid. This is:
A Liquefaction
B Storm surge
C Subsidence by drought
D Tephra fall
Answer: A. Liquefaction. Liquefaction occurs when saturated loose sediments lose strength during strong shaking and behave in a fluid-like way.
A long crack and offset in the ground directly along a ruptured fault is called:
A A lahar
B A storm tide
C Surface fault rupture
D A seiche
Answer: C. Surface fault rupture. Surface fault rupture is the permanent break and displacement that reaches the ground surface along a fault.
Which earthquake effect can directly trigger failures on steep slopes?
A A solar eclipse
B Ground shaking
C A change in longitude
D Low ocean salinity
Answer: B. Ground shaking. Strong ground shaking can destabilize slopes and trigger landslides or rockfalls.
The first seismic waves detected at a station are usually:
A Surface waves
B Tsunami waves
C Tidal waves
D P waves
Answer: D. P waves. P waves are compressional body waves and generally travel faster through Earth than other seismic wave types.
A large undersea earthquake generates a tsunami most directly when it:
A Sudden seafloor and water displacement
B Warms ocean air
C Strong winds cause surge
D Changes seawater colour
Answer: A. Sudden seafloor and water displacement Vertical seafloor displacement can move a large water column and generate a tsunami.
Why can two nearby districts report different earthquake intensity values?
A Exposure equals intensity
B Magnitude changes by district
C Local shaking and ground conditions
D Epicentre shifts after rupture
Answer: C. Local shaking and ground conditions Observed intensity varies with distance, rupture direction and local geology, among other factors.
Smaller earthquakes that follow a larger mainshock in the same general area are called:
A Aftershocks
B Storm tides
C Seiches
D Foreshocks in every case
Answer: A. Aftershocks. Aftershocks occur after a mainshock as the surrounding crust adjusts to the changed stress.
Which statement about tephra is accurate?
A Seawater evaporation
B Molten surface lava
C Airborne volcanic fragments
D Earthquake wave
Answer: C. Airborne volcanic fragments Tephra is fragmented material ejected during an eruption; it ranges from fine ash to larger volcanic blocks.
A fast, hot mixture of ash, rock fragments and gas rushing down a volcano’s flank is a:
A Tidal bore
B Dust devil
C Landslide scar
D Pyroclastic flow
Answer: D. Pyroclastic flow. Pyroclastic flows are hot, fast-moving currents of volcanic particles and gas.
A volcanic mudflow made of water and volcanic debris is known as a:
A Aftershock
B Storm surge
C Lahar
D Liquefaction zone
Answer: C. Lahar. A lahar is a water-rich flow of volcanic mud, debris and rock that moves down a volcano and its valleys.
Which setting is especially dangerous during heavy rain after volcanic ash has accumulated on slopes?
A Volcano-fed valleys
B Distant high plateau
C Deep offshore trench
D Remote flat desert
Answer: A. Volcano-fed valleys Rain can remobilize loose volcanic deposits into lahars that follow valleys and river channels.
Molten rock that reaches and flows across the land surface is called:
A Seismic slip
B Lava
C Pumice cloud
D Tephra fall
Answer: B. Lava. Magma is molten rock underground; once it erupts onto Earth’s surface it is called lava.
Which volcanic hazard is made of tiny fragments that can blanket distant areas downwind?
A Liquefaction
B Storm tide
C Ashfall
D Fault displacement
Answer: C. Ashfall. Wind can transport fine volcanic ash well beyond the volcano, where it can affect transport, health and infrastructure.
Which is a major concern for aircraft flying through a volcanic ash cloud?
A Changes airplane longitude
B Damages aircraft engines
C Improves fuel quality
D Creates ocean tsunamis
Answer: B. Damages aircraft engines Volcanic ash can be highly damaging to aircraft engines and flight systems, so ash advisories matter to aviation.
Rising magma may deform a volcano’s surface. Which observation can help monitor this change?
A Distant ocean tides
B River salinity decline
C Time-zone changes
D Geodetic ground swelling
Answer: D. Geodetic ground swelling Volcanic monitoring can measure ground deformation as magma moves and pressure changes beneath the surface.
Volcanic arcs commonly form above:
A Transform fault centres
B Descending plate boundaries
C Old cratons only
D Stable continental interiors
Answer: B. Descending plate boundaries Water and other volatiles from a subducting plate can promote melting and feed chains of volcanoes above subduction zones.
A hazard map around a volcano is useful because it can show:
A Exact eruption date and size
B Volcanic impact zones
C Personal readiness levels
D Certain future wind directions
Answer: B. Volcanic impact zones Volcano hazard maps outline potential impact zones based on past deposits, topography and volcanic processes.
A steep volcanic cone has snow cover. Which secondary hazard can follow rapid melting during an eruption?
A Hailstorm
B Meteorological drought
C Earthquake magnitude
D Lahar
Answer: D. Lahar. Eruptive heat can melt snow and ice, adding water to volcanic debris and generating lahars.
Why are pyroclastic flows especially life-threatening near an active volcano?
A Cold rainwater only
B Ocean-floor confinement
C Cooled-lava speed
D Fast, extremely hot flows
Answer: D. Fast, extremely hot flows Pyroclastic flows combine high temperatures and rapid movement, leaving little time for people in their path.
A landslide from a volcanic flank collapses into the sea. What additional hazard may be generated?
A A frost hollow
B A tsunami
C An aftershock scale
D A dust storm
Answer: B. A tsunami. A large landslide entering the sea can displace water and generate tsunami waves.