Difficulty: Hard
A sequence of 18 annual varves most directly records about:
A 9 years
B 36 years
C 18 years
D 180 years
Answer: C. 18 years. If each counted couplet represents one year, 18 varves record approximately 18 years of deposition.
A glacier margin shifts 600 m in 20 years. Its mean retreat rate is:
A 3 m/year
B 20 m/year
C 30 m/year
D 120 m/year
Answer: C. 30 m/year. Mean rate equals distance divided by time: 600 m ÷ 20 years = 30 m/year.
A glacial trough is 4 km wide and 1 km deep. Its width-to-depth ratio is:
A 4:1
B 1:4
C 2:1
D 5:1
Answer: A. 4:1. Divide width by depth: 4 km ÷ 1 km gives a width-to-depth ratio of 4:1.
An older moraine cut by a younger trough indicates at least two:
A Glacial episodes
B Lake cycles
C River captures
D Dune advances
Answer: A. Glacial episodes. A younger erosional feature that truncates an older moraine records a later phase of glacial activity.
A cirque floor lies at 2,100 m and its lip at 2,250 m. The vertical relief is:
A 50 m
B 100 m
C 350 m
D 150 m
Answer: D. 150 m. Subtract floor elevation from lip elevation: 2,250 m − 2,100 m = 150 m.
Three distinct moraine ridges represent at least how many former margin positions?
A One position
B Two positions
C Three positions
D Four positions
Answer: C. Three positions. Each distinct ridge marks a separate preserved glacier-margin position, so three ridges indicate at least three positions.
A basal till layer overlain by stratified sand and gravel most strongly suggests:
A Advance without melting
B Wind-only deposition
C Marine erosion
D Retreat with meltwater
Answer: D. Retreat with meltwater. The lower till records direct ice deposition, while overlying sorted sediment records later meltwater deposition.
A lake accumulates 12 m of sediment in 600 years. The mean rate is:
A 0.2 cm/year
B 2 cm/year
C 1 cm/year
D 20 cm/year
Answer: B. 2 cm/year. Twelve metres equals 1,200 centimetres; 1,200 cm divided by 600 years is 2 cm per year.
On a 1:25,000 map, a moraine is 8 cm from the modern terminus. Ground distance is:
A 2 km
B 0.2 km
C 1 km
D 20 km
Answer: A. 2 km. At 1:25,000, 1 cm represents 250 m; 8 cm represents 2,000 m, or 2 km.
An icefield covers 36 km², with 9 km² above its equilibrium line. Its accumulation-area ratio is:
A 0.20
B 0.40
C 0.75
D 0.25
Answer: D. 0.25. Accumulation-area ratio equals accumulation area divided by total area: 9 ÷ 36 = 0.25.
Varved lake clay overlies a moraine. Which deposit formed later?
A Lake clay
B Moraine
C Both together
D Neither deposit
Answer: A. Lake clay. The lake clay accumulated after the moraine was already present beneath the water body.
A lateral moraine stands 90 m above the modern ice surface. It indicates former glacier:
A Lower speed
B Higher salinity
C Greater thickness
D Smaller extent
Answer: C. Greater thickness. The former lateral-moraine elevation records a higher ice margin and therefore greater ice thickness at that location.
A rock-basin floor is 170 m below its outlet sill. If filled to the sill, maximum water depth is:
A 85 m
B 170 m
C 340 m
D 17 m
Answer: B. 170 m. The sill sets the outlet level, so the vertical difference from basin floor to sill is 170 m.
A cross-section shows a deep central trough with a shallow bedrock sill at its mouth. This pattern suggests:
A Glacial overdeepening
B River aggradation
C Coastal accretion
D Wind deflation
Answer: A. Glacial overdeepening. Glaciers can excavate valley floors below their outlets, leaving an overdeepened basin and sill.
Three moraine crests lie 4, 9, and 13 km from a fixed headwall. Outer-to-inner retreat distance is:
A 9 km
B 4 km
C 13 km
D 17 km
Answer: A. 9 km. The outer and inner crests are 13 km and 4 km from the headwall; their separation is 9 km.
A lower moraine is overlain by lake sediment, then cut by a younger moraine. This sequence records:
A One steady phase
B Multiple phases
C No retreat
D Only lake erosion
Answer: B. Multiple phases. The cross-cutting and superposition relationships show more than one glacial phase separated by lake deposition.
Paired lateral moraines on opposite valley sides can constrain a former glacier’s:
A Terminus age
B Flow speed
C Snowfall rate
D Surface width
Answer: D. Surface width. The distance between paired lateral moraines marks the approximate width of the former glacier at that cross-section.
The steep foresets in a glacial lake delta dip generally:
A Uphill
B Lakeward
C Upstream
D Alongshore
Answer: B. Lakeward. Delta foresets slope basinward into deeper lake water as the delta progrades lakeward.
An abandoned outwash surface stands 32 m above the modern stream. Relative incision is:
A 16 m
B 64 m
C 32 m
D 3.2 m
Answer: C. 32 m. The vertical difference between the terrace surface and modern stream level records 32 m of relative incision.
A kame terrace usually parallels a valley because it formed between ice and the:
A Valley wall
B Cirque floor
C Moraine crest
D Lake bottom
Answer: A. Valley wall. Kame terraces accumulate in the narrow space between glacier ice and an adjacent valley wall.
Two striation sets cross on the same bedrock panel. The set that cuts across the other is usually:
A Older set
B Both same age
C Not datable
D Younger set
Answer: D. Younger set. Cross-cutting relationships show that the grooves that truncate an earlier set formed later.
A sudden flood released from a glacier-dammed lake is a:
A Outwash fan
B Jökulhlaup
C Kame delta
D Rock glacier
Answer: B. Jökulhlaup. Jökulhlaup is the term for a glacier outburst flood released from an ice-dammed lake or related source.
A moraine-dammed lake differs from an ice-dammed lake by its barrier of:
A Moving ice
B Bedrock sill
C Sediment ridge
D Coastal dune
Answer: C. Sediment ridge. A moraine-dammed lake is held back by glacial debris rather than glacier ice itself.
In a lake delta, flat topsets pass into steep foresets and then finer:
A Till sheets
B Bottomsets
C Moraine crests
D Esker ridges
Answer: B. Bottomsets. A classic delta sequence has topsets, inclined foresets, and finer bottomsets beyond the delta front.
A glacial valley floor drops 120 m over 4 km. Its mean gradient is:
A 3 m/km
B 12 m/km
C 480 m/km
D 30 m/km
Answer: D. 30 m/km. Divide elevation change by distance: 120 m ÷ 4 km = 30 metres per kilometre.