Structural Geology MCQs (Set-3)

Difficulty: Medium

A layer bends upward into an arch, and both limbs dip away from the crest. What fold is it?

A Syncline
B Graben
C Anticline
D Monocline

A layer bends downward into a trough, and both limbs dip toward its axis. What fold is it?

A Anticline
B Horst
C Dome
D Syncline

An anticline is upright and not overturned; the beds are correctly younging upward. Which map pattern is expected in its core?

A Older strata are exposed in the center
B Younger strata are exposed in the center
C Every layer is the same age
D Only a fault gouge is exposed

A syncline is upright and not overturned; beds young upward. Which map pattern is expected in its core?

A Older strata are exposed in the center
B Younger strata are exposed in the center
C Only basement rock occurs in the center
D The core must be an igneous intrusion

A fault plane dips east. A rock block lies above the plane. Which term identifies that block?

A Footwall
B Fold limb
C Hanging wall
D Axial surface

A fault plane dips west. The block below the plane moves down relative to the block above. What fault is described?

A Normal fault
B Right-lateral strike-slip fault
C Joint
D Reverse fault

A block between two normal faults subsides relative to the sides. What structure forms?

A Graben
B Horst
C Anticline
D Dome

A block between two faults stands higher than adjacent blocks. What structure may it form?

A Graben
B Horst
C Syncline
D Basin

A fault shows 2 meters of vertical separation and 5 meters of horizontal separation. Which component is larger?

A The vertical component, or throw
B They are equal
C The horizontal component, or heave
D Neither can be measured on a fault

A map shows a bedding plane with a north-south strike and a 30-degree dip to the east. Which statement is correct?

A The plane is vertical and trends east-west
B The dip direction is north-south
C The strike is the steepest descent direction
D The plane slopes downward most steeply toward the east

Two roads cross a strike-slip fault. After movement, the road segment on the far side is displaced to the right from an observer’s position. What sense is it?

A Right-lateral
B Left-lateral
C Normal
D Reverse

A fault has both horizontal offset and a measurable vertical separation. Which classification is most appropriate?

A Pure strike-slip
B Oblique-slip
C Pure dip-slip
D Joint

A sedimentary sequence shows a circular pattern with older rocks in the middle and beds dipping outward. What structure is likely?

A Basin
B Syncline
C Dome
D Graben

A map shows concentric beds dipping inward toward a central area where the youngest rocks occur. What is likely?

A Dome
B Anticline
C Horst
D Structural basin

A planar layer has a strike of east-west and dips 45 degrees south. Which line lies horizontally within the plane?

A An east-west line
B A north-south line pointing down the dip
C A vertical line
D A line parallel to the fold hinge in every case

A rock layer is folded but not broken. Which broad deformation style is shown?

A Brittle faulting
B Ductile deformation
C Jointing
D Unconformity formation

A rock layer is cut and offset along a fracture. Which structure is present?

A Fold
B Joint with no displacement
C Fault
D Bedding plane only

A fracture cuts a rock but field evidence shows no movement along it. What is the best term?

A Fault
B Thrust
C Graben
D Joint

A reverse fault has a low-angle fault plane. What is the more specific name commonly used?

A Thrust fault
B Normal fault
C Transform fault
D Monocline

A set of folds has a common axial-plane orientation and similar hinge directions. What can this pattern indicate?

A A single river sorting sediment
B A shared regional deformation event or stress field
C Only volcanic cooling contraction
D A random mineral color change

An anticline is overturned so both limbs dip in the same direction. Why can age interpretation become difficult?

A Every bed becomes the same age
B Folds stop preserving any layer boundaries
C The original stratigraphic younging direction may be reversed on one limb
D The structure must be a graben

A layer changes from nearly horizontal to steeply inclined through a single step-like bend. Which fold is a good fit?

A Anticline
B Syncline
C Dome
D Monocline

A fold’s hinge line slopes 20 degrees below horizontal. What descriptor applies?

A Plunging
B Recumbent
C Horizontal
D Unfaulted

A fault surface bears parallel scratches aligned with the direction of slip. What are these marks called?

A Cross-beds
B Slickensides
C Mud cracks
D Vesicles

A fault scarp is present in young sediment, but erosion has softened its slope. What does the scarp originally record?

A A fold hinge at the surface
B A volcanic ash deposit
C Surface displacement along a fault
D A river meander cutbank