Control-loop purpose
- A control loop compares a measured process variable with a desired set point and computes corrective action.
- Typical controlled variables include flow, level, pressure, temperature and composition.
Measurement and sensors
- Sensors and transmitters convert process conditions into usable signals.
- Measurement range, accuracy, response time, installation and maintenance affect control performance.
Controller and final element
- A controller uses the error between set point and measurement to calculate an output.
- Control valves, variable-speed drives and heaters are common final control elements.
Open and closed loop
- Open-loop control acts without using measured output feedback.
- Closed-loop feedback responds to measured deviations but may be affected by delay, noise and disturbances.
P, PI and PID actions
- Proportional action responds to current error; integral action accumulates error over time.
- Derivative action responds to error change and can improve damping but is sensitive to noisy signals.
Dynamic behavior and tuning
- Process gain, time constants and dead time shape closed-loop response.
- Controller tuning balances speed, overshoot, disturbance rejection and stability.
Basic feedback-loop elements
| Element | Role | Example |
|---|---|---|
| Sensor / transmitter | Measure process variable | Temperature transmitter |
| Controller | Compare measurement with set point | PID controller |
| Final element | Change manipulated input | Control valve |
| Process | Respond to manipulated input | Heated tank |
Advanced loop structures
- Cascade control uses a primary loop set point to drive a faster secondary loop.
- Feedforward action uses a measured disturbance to act before its full effect appears in the controlled variable.
Implementation and safeguards
- Signal scaling, valve fail position, alarms and interlocks affect loop implementation and safety.
- Loop checks and performance monitoring confirm that sensors, controller logic and actuators work together.