Difficulty: Hard
A 9-hPa difference spans 300 km. What is the average gradient per 100 km?
A 1 hPa per 100 km
B 2 hPa per 100 km
C 3 hPa per 100 km
D 9 hPa per 100 km
Answer: C. 3 hPa per 100 km. Divide 9 hPa by three 100-km intervals to get 3 hPa per 100 km.
A 1.2 mΒ² plate experiences 98,000 Pa. What force acts on it?
A 81,700 N
B 117,600 N
C 98,000 N
D 196,000 N
Answer: B. 117,600 N. Force equals pressure times area: 98,000 multiplied by 1.2.
Using p = 101,000 Pa and g = 9.8 m/sΒ², what is column mass per square metre?
A About 10,300 kg
B About 1,030 kg
C About 9,800 kg
D About 101,000 kg
Answer: A. About 10,300 kg. From p = mg/A, mass per area is p divided by gravity.
Convert 101,325 Pa into hectopascals.
A 101.325 hPa
B 10,132.5 hPa
C 1013.25 hPa
D 101,325 hPa
Answer: C. 1013.25 hPa. Divide pascals by 100 to convert to hectopascals.
If 760 mmHg equals 1013.25 hPa, about how much is 750 mmHg?
A About 750 hPa
B About 1000 hPa
C About 900 hPa
D About 1100 hPa
Answer: B. About 1000 hPa. Scaling 1013.25 hPa by 750 divided by 760 gives approximately 1000 hPa.
A 500-hPa surface averages near what altitude in the standard atmosphere?
A About 1.2 km
B About 5.6 km
C About 11 km
D About 18 km
Answer: B. About 5.6 km. The standard-atmosphere 500-hPa level is roughly 5.6 km above sea level, with actual height varying.
A 500-hPa height contour is higher in region A than B. What is likely in A’s column?
A Greater mean cold
B No air mass
C Higher surface pressure always
D Greater mean warmth
Answer: D. Greater mean warmth. Warmer columns are thicker, raising constant-pressure surfaces such as 500 hPa.
A map’s isobars are 1008, 1004, and 1000 hPa. What is the interval?
A 2 hPa
B 4 hPa
C 8 hPa
D 12 hPa
Answer: B. 4 hPa. Each adjacent line differs by four hectopascals.
Why can sea-level pressure correction be imperfect over mountains?
A Actual temperature may differ
B Gravity is removed
C Barometers stop working
D Isobars cross mountains
Answer: A. Actual temperature may differ. The reduction uses an assumed temperature profile that may differ from real air below the station.
If isobars tighten while pressure contrast stays similar, what changes?
A Gradient becomes weaker
B Gradient becomes stronger
C Pressure becomes uniform
D Altitude becomes constant
Answer: B. Gradient becomes stronger. The same pressure change over a shorter distance produces a stronger gradient.
Which relation describes hydrostatic balance?
A dp/dz = -rho g
B p = rho + g
C dp/dz = rho g
D p = g/rho
Answer: A. dp/dz = -rho g. In hydrostatic balance, pressure decreases upward at a rate proportional to density and gravity.
Why is pressure decrease with altitude not linear?
A Earth stops rotating
B Gravity changes sign
C Isobars become vertical
D Air density also decreases
Answer: D. Air density also decreases. Each higher layer contains less dense air, so equal height intervals do not remove equal pressure.
In a standard atmosphere, pressure near 5.6 km is roughly what fraction of sea-level pressure?
A About one tenth
B About three quarters
C About one half
D About one quarter
Answer: C. About one half. Pressure near the standard 500-hPa level is about half the 1013-hPa sea-level value.
A pressure surface has the same height at two nearby points. What is equal there?
A Geopotential height
B Surface pressure
C Air temperature
D Station elevation
Answer: A. Geopotential height. Equal height contours on a constant-pressure chart identify equal geopotential height.
Which statement distinguishes an isobaric chart from a constant-height map?
A It fixes latitude
B It fixes pressure
C It fixes temperature
D It fixes wind speed
Answer: B. It fixes pressure. An isobaric chart follows a constant-pressure surface rather than a constant altitude.
An aircraft altimeter is set to local QNH. What reference does it use?
A Runway pressure only
B 500-hPa height
C Mean sea-level pressure
D Cabin pressure
Answer: C. Mean sea-level pressure. QNH is the local sea-level pressure setting used to indicate altitude above mean sea level.
At the reference airfield, what does QFE represent?
A Sea-level pressure
B Cabin pressure
C Upper-air pressure
D Airfield pressure
Answer: D. Airfield pressure. QFE is the atmospheric pressure measured at the airfield reference elevation.
A 4-hPa pressure change spans 80 km. What is the gradient per 100 km?
A 2 hPa per 100 km
B 4 hPa per 100 km
C 8 hPa per 100 km
D 5 hPa per 100 km
Answer: D. 5 hPa per 100 km. Four divided by 80 and multiplied by 100 gives 5 hPa per 100 km.
Which pressure change is larger, 15 hPa over 500 km or 6 hPa over 100 km?
A 6 hPa over 100 km
B 15 hPa over 500 km
C They are equal
D Cannot compare units
Answer: A. 6 hPa over 100 km. The gradients are 3 and 6 hPa per 100 km, respectively.
At equal temperature, higher air density generally corresponds to what?
A Lower pressure
B Zero pressure
C Unchanged pressure always
D Higher pressure
Answer: D. Higher pressure. For a gas at the same temperature, greater density corresponds to greater pressure.
What primarily supports atmospheric pressure at Earth’s surface?
A Weight of the air column
B Earth’s magnetic field
C Ocean tides alone
D Cloud reflection
Answer: A. Weight of the air column. Surface pressure results from the gravitational weight of air above each unit area.
A station reads 820 hPa at altitude. Which value is not its direct observation?
A Station pressure
B Local ambient pressure
C Sea-level reduced pressure
D Barometer reading
Answer: C. Sea-level reduced pressure. Sea-level pressure is calculated from the station reading using an elevation correction.
What does a steep horizontal pressure gradient usually support?
A No air movement
B Permanent calm
C Vertical pressure only
D Stronger winds
Answer: D. Stronger winds. A strong gradient force tends to accelerate air more strongly, though other forces affect wind.
If a pressure surface rises from 5.4 km to 5.8 km, what changed?
A Its pressure value
B Its unit label
C Its geometric height
D The planet’s radius
Answer: C. Its geometric height. The pressure surface keeps the same pressure while its height varies spatially.
A pressure map shows 1016 hPa outside and 1000 hPa inside closed lines. What center is shown?
A Low pressure
B High pressure
C A ridge only
D No pressure center
Answer: A. Low pressure. Pressure decreases inward across the closed lines, identifying a low-pressure center.