An unsaturated parcel starts at 20°C and rises 1 km. Using a dry adiabatic rate of 9.8°C/km, estimate its temperature aloft.
A 20°C
B 29.8°C
C 13.5°C
D 10.2°C
Answer: D. 10.2°C. The parcel cools about 9.8°C, leaving it near 10.2°C.
The environmental lapse rate is 8°C/km. Compared with a dry parcel cooling at 9.8°C/km, how is the layer classified for unsaturated motion?
A Isothermal
B Unconditionally convective
C Stable
D Absolutely unstable
Answer: C. Stable. The environment cools more slowly than the lifted parcel, so the parcel becomes cooler than its surroundings.
An unsaturated layer’s environmental lapse rate is 11°C/km. What is the likely stability?
A Isothermal
B Absolutely stable
C Absolutely unstable
D Stable for all parcel types
Answer: C. Absolutely unstable. The environment cools faster than a dry parcel, allowing a lifted parcel to remain buoyant.
A parcel cools from 24°C to 14°C while rising 1 km. What is its approximate lapse rate?
A 10°C/km
B 1°C/km
C 38°C/km
D 24°C/km
Answer: A. 10°C/km. A 10°C change over 1 km gives a lapse rate of 10°C/km.
Why is the moist adiabatic lapse rate usually lower than the dry rate?
A Condensation releases latent heat
B Cloud droplets raise air pressure
C Gravity weakens in clouds
D Saturated air cannot expand
Answer: A. Condensation releases latent heat. Latent heat released during condensation partly offsets expansion cooling.
A rising unsaturated parcel cools without exchanging heat with its environment. What causes the cooling?
A Compression by increasing pressure
B Condensation before saturation
C Expansion as surrounding pressure falls
D Friction with the surface
Answer: C. Expansion as surrounding pressure falls. A parcel expands against lower pressure as it rises, lowering its internal energy and temperature.
What temperature change occurs as an air parcel descends into higher pressure without heat exchange?
A At dew point
B It becomes saturated automatically
C It warms by compression
D It cools by expansion
Answer: C. It warms by compression. Increasing pressure compresses descending air and raises its temperature.
Air at 18°C can hold 15 g/m³ of vapour at saturation and currently contains 9 g/m³. What is relative humidity?
A 40%
B 90%
C 150%
D 60%
Answer: D. 60%. Relative humidity is 9 divided by 15, multiplied by 100: 60%.
A parcel contains 8 g/kg of water vapour and reaches saturation at 10 g/kg. What is its relative humidity?
A 18%
B 20%
C 125%
D 80%
Answer: D. 80%. The ratio 8/10 equals 0.8, or 80%.
At constant pressure, air is warmed without adding water vapour. What usually happens to its relative humidity?
A It decreases
B It increases
C It stays at 100%
D Reaches dew point
Answer: A. It decreases. Warming raises saturation capacity while actual vapour stays nearly fixed, lowering relative humidity.
At what level does a rising unsaturated parcel first reach saturation?
A Lifting condensation level
B Freezing level only
C Stratopause
D Tropopause
Answer: A. Lifting condensation level. At the lifting condensation level, parcel temperature reaches its dew point.
Why does a layer with temperature increasing upward resist vertical convection?
A Pressure increases above the surface
B Water vapour cannot exist there
C Cooler, denser lifted parcel
D The layer has no gravity
Answer: C. A lifted parcel tends to be cooler and denser than the air around it. A temperature inversion is strongly stable because displaced air tends to return toward its starting level.
An environmental lapse rate lies between the moist and dry adiabatic rates. What does this imply?
A All parcels stay stable
B Only descending parcels accelerate upward
C The layer is isothermal
D Unsaturated stable, saturated unstable
Answer: D. Unsaturated parcels can be stable while saturated parcels are unstable. This is conditional instability: saturation changes the parcel’s cooling rate and buoyancy.
Which process transports much surface heat upward through the troposphere?
A Magnetic induction
B Tidal friction
C Convection by rising warm air
D Conduction through solid rock
Answer: C. Convection by rising warm air. Surface heating drives buoyant thermals that carry heat upward.
When water evaporates from a surface, what happens to latent heat?
A Energy stored in vapour
B Energy is destroyed
C Raises pressure without heat
D It becomes visible light
Answer: A. Energy is absorbed and stored in water vapour. Evaporation absorbs latent heat from the surface; condensation later releases it.
Why is a constant-pressure surface usually higher over a warm column than over a cold column?
A Pressure rises in warm air
B Warm air has no mass
C Surface is sea level
D Expanded, thicker warm column
Answer: D. The warm column is expanded and thicker. A warmer air column expands, so the same pressure interval spans more vertical distance.
In hydrostatic balance, what approximately balances the downward weight of air?
A The upward pressure-gradient force
B The Coriolis force
C Cloud reflection
D Surface friction
Answer: A. The upward pressure-gradient force. The upward pressure-gradient force balances gravity’s downward force in hydrostatic conditions.
What does one scale height represent in a simple exponential atmosphere?
A Height for e-fold pressure fall
B Zero-pressure altitude
C Fixed cloud-base height
D Full tropospheric depth
Answer: A. A height over which pressure falls to about 1/e of its starting value. After one scale height, pressure is approximately 37% of its initial value.
Why does a rising air parcel cool even when no heat enters or leaves it?
A Motion stops in clouds
B Expands against lower pressure
C Gravity turns off
D Its molecules stop colliding
Answer: B. It does work expanding against lower surrounding pressure. Expansion work lowers the parcel’s internal energy, producing adiabatic cooling.
Clouds reflect some daytime sunlight and absorb some outgoing infrared radiation. What does this show?
A Clouds always cool the climate
B Depends on both energy flows
C Clouds always warm the climate
D No radiative cloud effect
Answer: B. Their net radiative effect depends on both energy flows. Clouds can cool by reflecting shortwave sunlight and warm by absorbing longwave radiation.
Which statement distinguishes environmental lapse rate from adiabatic lapse rate?
A Only above thermosphere
B Environment versus moving parcel
C Adiabatic rate is always 6.5°C/km
D Alternate pressure names
Answer: B. Environmental rate describes surrounding air; adiabatic rate describes a moving parcel. The environmental lapse rate is the actual vertical profile; adiabatic rates describe parcel temperature change.
How do cloud droplets commonly begin forming in slightly supersaturated air?
A Nitrogen freezes into droplets
B Ozone becomes liquid
C Gravity creates water molecules
D Water condenses on aerosol nuclei
Answer: D. Water condenses on aerosol nuclei. Aerosol particles provide surfaces for condensation into tiny cloud droplets.
What does atmospheric albedo measure?
A The water-vapour content at saturation
B Reflected solar fraction
C Upward pressure-fall rate
D Dry-air nitrogen percentage
Answer: B. The fraction of incoming solar radiation reflected. Albedo is the fraction of incident solar energy reflected by a surface or system.
Which radiation is mainly absorbed and re-emitted by greenhouse gases?
A All visible sunlight equally
B Terrestrial infrared radiation
C Sound energy
D Only cosmic rays
Answer: B. Terrestrial infrared radiation. Earth emits energy largely as infrared radiation, which greenhouse gases absorb and emit.
Why does surface pressure decline as an observer moves upward?
A Observer shifts poleward
B Less overlying air mass
C Gravity reverses direction
D Air molecules lose their weight
Answer: B. There is less air mass overhead. Pressure reflects the weight of overlying air, which decreases with altitude.